How to: Gladiator Windshield Banner Install. Works on Wrangler too

แชร์
ฝัง
  • เผยแพร่เมื่อ 7 ก.ย. 2024

ความคิดเห็น • 9

  • @chuckwinchester9939
    @chuckwinchester9939 4 ปีที่แล้ว +1

    Where did you get the replacement USB port in the back of the bed? Love the build. About to start mine. Keep up the good content and the love of overlanding!!

    • @OFFMAPRacing
      @OFFMAPRacing  4 ปีที่แล้ว

      www.amazon.com/dp/B07JHH5YP4?ref=ppx_pop_mob_ap_share
      Use 10 ga wire to get back there. You'll need the diameter to carry good voltage that far.

    • @chuckwinchester9939
      @chuckwinchester9939 4 ปีที่แล้ว +1

      You can’t use the wire that is already run to the back? Oh wow. Thanks for the heads up.

    • @OFFMAPRacing
      @OFFMAPRacing  4 ปีที่แล้ว

      I didn't have wires to the back. I decided against the cargo management package because 115 back there that had to be switched back on every time the key cycles wasn't going to work. My Jeep had a blank panel and no wires here

  • @Patrick21684
    @Patrick21684 4 ปีที่แล้ว

    I used this video to guide me on putting my “Rock Krawler” windshield sticker on. Rock popped up off a truck on interstate and cracked it right down the middle the next day. I went back and watched the video again. Couldn’t find directions on how to dodge rocks on the interstate anywhere. 🤣🤣🤣

    • @OFFMAPRacing
      @OFFMAPRacing  4 ปีที่แล้ว

      Hahahhahahaha. If I could figure that out for Jeeps I'd have a marketable product

  • @206brandon
    @206brandon 4 ปีที่แล้ว

    After replacing my windshield 3 times in 2 years due to rock chips and cracks, I refuse to put another sticker or tint on my windshield. Love my Jeep but the windshield is terrible.

    • @OFFMAPRacing
      @OFFMAPRacing  4 ปีที่แล้ว

      I've gotten lucky. To this point I haven't replaced one windshield in my 2 JKs or the gladiator

  • @Sniperssx
    @Sniperssx 3 ปีที่แล้ว

    wish can have free banner :)