I just re-place the leak detection pump on this vehicle a few months ago is that anywhere near the purge control cylinder that would go out a few months later?
I bought a new one because I thought the old one was bad. I put the new one in and the new one wouldn't open either. I checked to see if it was getting voltage and the multimeter was at 13.5. What could be the problem
While fuel filling, vehicle rpm is going down and engine went off, after a few try it's will start.. But only it happen during fuel filling.... If give accelerated during fuel filling no issue...
i have the exact same issue, once gas cap is opened and pressure escapes. Car will have a hard time starting and rough idles for a couple minutes. Did you happen to solve the issue?
I've been having a car for 15 years a long time but I have never changed vvt valve and the bleed valve but the cat is still Ok should I replace them or wait until sth goes wrong
Hello. I have a 2006 Nissan B13 Sentra (also known as sunny or tsuru). Sometimes it smells as some fuel were comming out. One day i was able to see there was some fuel comming out from the canister, so i changed it. When I open the fuel cap there's a noise that people say it is some fuel vapor, and that I have to change my evap valve as to stop it and vapor be able to get to canister, but I haven't been able to find it. My question is if I am able to use an evap valve from another car and what it would be. Thank you.
Sorry but I have a OBD 1 1997 Buick Riviera and mine has this emission vapor canister purge vacuum switch that is part of this system. My car sound like it runs and idles fine but, at times and it has become more obvious it will choke out when I press the gas fast or just die. It will also stumble and almost die when going up a hill and I press it just a bit to get it going and it acts like I running a lawnmower engine and will jerk and make you think it has bad bad gas, or several spark plugs are just not working.. The plugs are very new and the gas line filter was replaced and so those are the the problems so I suspect a vacuum problem somewhere. I really can't trust it going on the fast highway now, but it used to be top performer if I wanted it be. It is a supercharge 3.8 V-6, I wondered on the vacuum side that maybe the problems was the supercharger cut off valve, and thought the connector was cracked and order the part, a day before I got it I check it over again and that connection was not cracked as I thought but I replaced it anyway and tested the old one and one side of the vacuum connection was no longer holding the vacuum very well. So that was part of the problem but did not fix it. I got the purge vacuum switch in the mail today and did not put it on yet. Too hot today. But along that same line on this vacuum switch the other hose connection on the top that goes to the purge valve, that hose cracks often and I have to replaces it about every 6 months or more often. So maybe that was not supposed to do that either but I have only had this weird running power problem now for the past 5 months. It first started out as a random almost stall as I would gain more speed to get on the highway, leaving me with the car in a awkward spot. The next time I could just gun it and it would really do great. Now it is like some thing of a car from the 1930's.
HOW CAN YOU TELL IF ITS THE PURGE VALVE OR THE CANISTER CLOSE VALVE THAT IS ACTING UP? SO FAR BAD MPG CANT GO ON HIGHWAY BECAUSE CANT GO OVER 60 WITHOUT BEING AT 4000 RPM. ALSO CAN THE PCV VALVE BE CLEANED WITH BRAKE CLEAN? IF I LIKE LET IT SIT IN THERE ITS STUCK ON OPEN I NEED TO FIX THE ONE I HAVE UNTIL PART ARRIVES
Whoever made this AI video that informs you the method of fixing the part is to replace it needs to be banned from making videos. It might sound harsh but at this point this crap is just spam.
![ผัวเถื่อน - ยูริ โตเกียวมิวสิค [ OFFICIAL MUSIC VIDEO ]](http://i.ytimg.com/vi/P08ORRVDGl8/mqdefault.jpg)
How to fix : method 1 replace the valve... Nice fix buddy
😂
Thank you for sharing I appreciate it.😮
Hope it helps! Thanks for watching!
Thank you for the video. Where would this be on an Opel Corsa E. I have told the fuel tank would need to be removed to get to it. How true is this?
HI Max, you can find it behind the intake manifold.
I just re-place the leak detection pump on this vehicle a few months ago is that anywhere near the purge control cylinder that would go out a few months later?
Hi kimberly, it should last up to five years or 50,000 miles, whichever comes first.
I bought a new one because I thought the old one was bad. I put the new one in and the new one wouldn't open either. I checked to see if it was getting voltage and the multimeter was at 13.5. What could be the problem
While fuel filling, vehicle rpm is going down and engine went off, after a few try it's will start.. But only it happen during fuel filling.... If give accelerated during fuel filling no issue...
Can you please provide us with your vehicle's year, make and model? Also, please confirm if this is the only code you're getting.
i have the exact same issue, once gas cap is opened and pressure escapes. Car will have a hard time starting and rough idles for a couple minutes. Did you happen to solve the issue?
I've been having a car for 15 years a long time but I have never changed vvt valve and the bleed valve but the cat is still Ok should I replace them or wait until sth goes wrong
Hello, please provide us with your vehicle's year, make and model.
@@nondainc Thank you for being so kind
Chaverlat Aveo 2007 manual gearbox
Where is this in a 2016 Ford fusion. 1.5 turbo?
Hello, you can find it at the back center of the engine compartment, right next to the throttle body.
How bout the location on a 2019 ford edge titanium?
Hi Denise, kindly remove the air intake tube and you'll find it there. Thanks for watching!
@nonda where is it located on an 09 volvo xc70?
I would put the wilderbeast on a game reserve and claim hunting season 👍
Is it possible to twist it to make the car not move? Can it be cleaned? I hope for a response from you
Please provide us with your vehicle's year, make and model.
Hello. I have a 2006 Nissan B13 Sentra (also known as sunny or tsuru). Sometimes it smells as some fuel were comming out. One day i was able to see there was some fuel comming out from the canister, so i changed it. When I open the fuel cap there's a noise that people say it is some fuel vapor, and that I have to change my evap valve as to stop it and vapor be able to get to canister, but I haven't been able to find it. My question is if I am able to use an evap valve from another car and what it would be. Thank you.
Hi, it sound a little bit risky. So we suggest you find a profession machanic for more suggestions according to your actual problems.
Sorry but I have a OBD 1 1997 Buick Riviera and mine has this emission vapor canister purge vacuum switch that is part of this system. My car sound like it runs and idles fine but, at times and it has become more obvious it will choke out when I press the gas fast or just die. It will also stumble and almost die when going up a hill and I press it just a bit to get it going and it acts like I running a lawnmower engine and will jerk and make you think it has bad bad gas, or several spark plugs are just not working.. The plugs are very new and the gas line filter was replaced and so those are the the problems so I suspect a vacuum problem somewhere. I really can't trust it going on the fast highway now, but it used to be top performer if I wanted it be. It is a supercharge 3.8 V-6, I wondered on the vacuum side that maybe the problems was the supercharger cut off valve, and thought the connector was cracked and order the part, a day before I got it I check it over again and that connection was not cracked as I thought but I replaced it anyway and tested the old one and one side of the vacuum connection was no longer holding the vacuum very well. So that was part of the problem but did not fix it. I got the purge vacuum switch in the mail today and did not put it on yet. Too hot today. But along that same line on this vacuum switch the other hose connection on the top that goes to the purge valve, that hose cracks often and I have to replaces it about every 6 months or more often. So maybe that was not supposed to do that either but I have only had this weird running power problem now for the past 5 months. It first started out as a random almost stall as I would gain more speed to get on the highway, leaving me with the car in a awkward spot. The next time I could just gun it and it would really do great. Now it is like some thing of a car from the 1930's.
Thanks for sharing your experience. Hope our video helps!
My check is comes on then off the code that's keeps throwing is p0445 but my active air flap on my dash pops up for a little bit
if you own an OBD II device, please run a scan and try to clear the code.
On a 2011 Ford Fusion SPORT 3.5 I cannot find it under the hood Could it be anywhere else??
Hi Anthony, you can find it at the back center of the engine compartment, right next to the throttle body.
@@nondainc Ok thank you, Ill try taking the intake and throttle body off and looking for it around there!
Recommendations on where to find a new one? I have a 1998 Nissan maxima and I can't find one other than ebay and I don't trust eBay.
HOW CAN YOU TELL IF ITS THE PURGE VALVE OR THE CANISTER CLOSE VALVE THAT IS ACTING UP? SO FAR BAD MPG CANT GO ON HIGHWAY BECAUSE CANT GO OVER 60 WITHOUT BEING AT 4000 RPM. ALSO CAN THE PCV VALVE BE CLEANED WITH BRAKE CLEAN? IF I LIKE LET IT SIT IN THERE ITS STUCK ON OPEN I NEED TO FIX THE ONE I HAVE UNTIL PART ARRIVES
Please provide us with your vehicle's year, make and model.
hi, i just saw the video,
does the purge valve affect the RPM to go up to be high, or sometimes on the other hand the RPM goes down?.
Yes.
@@nondainc 🙏
hi< where is this located on a Range Rover Supercharged 2015?
Hello, you can find it in the vacuum line between the fuel vapor containment canister and the intake manifold.
Were is it on a Hyundai accent 2017 hatchback
Hello, it is located in the vacuum line between the fuel vapor containment canister and the intake manifold.
Your Method of fixing it is to replace it? WTF.
Whoever made this AI video that informs you the method of fixing the part is to replace it needs to be banned from making videos. It might sound harsh but at this point this crap is just spam.
Where is it on an 09 volvo xc70?
Hello, kindly have a look at the engine compartment near the brake master cylinder.