Got me there for a second when you said it takes 4 gallons 🤣 I was like wait what?? Then you said 5.5 quarts lol. Thank you for this video. I am going to be doing this to my 2012 T&C. 👍
I appreciate your content and the only thing I would add would be short disclaimers like “make sure there is adequate ventilation when running vehicles, please exercise safety when taking on any job and add a tag line “ from K-Diagnostic’s be safe, just a turn of that wrench can get it done.
I have to replace 2 Ox Sensors on my 2014 Town and country van. They are both upstream. I guess I should replace the downstream sensors at the same time? When you replace the transmission filter and oil, should you do a flush of it???
@deanjagger1190 when you replace the sensor you don't need to replace all the sensors, you can just replace the faulty sensor amd about the transmission! you can just do a drain and fill, that's ok too!
Hi , good video , one little question my friend, what will you do if you finish the job and you have a oil pan leaking , How you will fix it. ? Thank you
@@KITS_Auto_and_Truck_Repair Thank you. You are doing a great work for lots of widows, veterans, sick elderly, and orphans (praise God). Please take in some young apprentices and teach them, too. Bless you.
You put in 5 litres, which is 5.3 quarts + another 1.5 quarts for a total of 6.8 quarts of transmission fluid in. This is 1.3 quarts more than you wanted to put in. Won't over filling by this much cause problems in the transmission?
In your video the large trans fluid container says “1.3 gallons” on it. 1.3 gallons = 5.2 quarts! (Check any online calculator!!) 5.2 + you added 1 full quart bottle + 1/2 (That’s 6.2 and 1/2 quarts!) 😮
My mother has 2015 Dodge Caravan and MPG has dropped to about 12 and 13 mpg City but Hwy it will increase up to about 18 or 19 depending on how long she drive, how can we increase the city performance, thank you, Fitz from Rochester, NY
Instead of dropping the pan first in order to remove the transmission fluid, why didn't you stick a rubber hose in from the top and transfer a majority of the fluid? Doing so would eliminate A LOT of potential mess all over your garage floor or driveway.
I appreciate your Work but for me it wasn't complete ? 🤔 Because it seem like you forgot to flush the lines the one that goes to the RADIATOR those need to be Flush 👈 I m right or wrong..🤔
It was a drain and fill, not a flush. I would be very cautious doing a flush as it could dislodge something I wouldn't want flowing through the valve body.
svhebert Good question, I did a drain and fill not a flush, a flush requires draining everything including the torque converter, and there was no metal shavings in the oil pan. so when you do a drain and fill you don't have to drain the lines!
He forgot to start the engine for 15 sec and switch to reverse and drive couple times before re-install the new pan and filter to force the residual old oil out of the converter.
@@KITS_Auto_and_Truck_Repair as a 30 years garage manger and licensed mechanic at Mercedes Berlin Germany that’s the standard. Chrysler pretty much same as Mercedes.
![ละลาย (LALALYE) - DAOU PITTAYA ต้าห์อู๋ พิทยา [OFFICIAL MV]](http://i.ytimg.com/vi/wo6r9TgausI/mqdefault.jpg)
Best video I’ve seen so far on changing transmission filter on this specific vehicle. High quality image. Thanks for sharing!
@misaelarreola9965 My Pleasure! I'm glad to hear that the video was helpful!
Love your no-nonsense instructions covering all the details, great job..
@user-rr5wp6qm9o Thank you!!
I like the repeats and summaries. That's a very good teacher technique. Good camera work.
@davidb2206 Thanks!
Thank you so much.. Now I know how to service my transmission without letting the dealership rob me.
@irawestmoreland7660 My Pleasure!
Great video. Shows everything with step by step instructions.
@scottrainey1056 Thank you!
How many litter of trams. Fluid
Very good explanation for this video thank you
I have this exact van. I thank you for giving us this amazing tutorial
@chezarose My Pleasure!
Very good video! Best I've seen! 👍
@freemind.. Thank you!
High quality tutorial for changing the oil and pan process
@lrobie123 Thank you!
Got me there for a second when you said it takes 4 gallons 🤣 I was like wait what?? Then you said 5.5 quarts lol. Thank you for this video. I am going to be doing this to my 2012 T&C. 👍
@thomasjohnson8517 Lol!! My Pleasure!
-Excellent explanation! Quick, concise and very informative 🤛
DinhaS Thank you, I appreciate it!
Good video very informational didn't rush through video explained everything clear 1000 thumbs up.
Jason Soisson Thank you!
Thank you for the information I thought you did a great job showing me what needs to be done
@user-cy1dc9tb8e My Pleasure!
thank you so much bro. I learned a lot from this video. I have one of those van, so it is worth a lesson you provided.
@Exposure270 My Pleasure!
Very easy explanation. Easy to follow. Thanks
cr1m1cYT My Pleasure!
great description. Much appreciated!
@baysbill Thank you!
thanx for sharing chap, starting a new family and dental practice, need to save coins and diy
@markbrown1609 My Pleasure! Good luck with your project!
Good Video learned what I needed to do mine thank you.
MrCondog47 My Pleasure!
I appreciate your content and the only thing I would add would be short disclaimers like “make sure there is adequate ventilation when running vehicles, please exercise safety when taking on any job and add a tag line “ from K-Diagnostic’s be safe, just a turn of that wrench can get it done.
Fitzroy Burke Sounds good!
I get it,some folks anit got the since t
Yo ventalate,hence their childen eat tide pod
I appreciate the video it really helped a lot thank you brother
David Fisher My Pleasure!
Excellent travail merci beaucoup frère
Younes Majid Merci!
Another good video.
Happy Motoring.
MostlymoparIH Thank you!
God bless you 🙏🏽🙏🏽🙏🏽 and thank you !
@PapaA6. My Pleasure! Thanks
Great video. Thank you 🙏🏻
@mikecaudill8861 My Pleasure!
Hi.
Thanks for the cool instructions, but please tell me how much oil did you pour in??
@muchaflipper4349 My Pleasure! About 5.5 quarts or 6 quarts if I remember correctly
Thank you for sharing, my Town & Country 2011 has only 68000 miles
When should I change the transmission fluid and filter
@im11000 wait around 80k miles
Great video
@michaelwagner3961 Thanks!
I have to replace 2 Ox Sensors on my 2014 Town and country van. They are both upstream. I guess I should replace the downstream sensors at the same time? When you replace the transmission filter and oil, should you do a flush of it???
@deanjagger1190 when you replace the sensor you don't need to replace all the sensors, you can just replace the faulty sensor amd about the transmission! you can just do a drain and fill, that's ok too!
Hi , good video , one little question my friend, what will you do if you finish the job and you have a oil pan leaking , How you will fix it. ? Thank you
@JPCASH1963 I would reseal it!
loved it and informative.
Hector Boyar Thanks
Well done!
Thomas Houle Thank you!
What causes the transmission in these to "slip" on start-up? It only happens on start-up, and not often. Thanks.
@davidb2206 you might be low on oil or your torque converter is about to fail!
@@KITS_Auto_and_Truck_Repair Thank you. You are doing a great work for lots of widows, veterans, sick elderly, and orphans (praise God). Please take in some young apprentices and teach them, too. Bless you.
Which side is the Transmission pan located on ?
@dreamlife8253 it's under the transmission
K Diagnostic always good job nice and clean, please the silent or Cilincon how long is most take before start the engine? Thanks you my boss 🙌
Suleman Habib Thanks Bro! About 5 - 10 minutes!
You put in 5 litres, which is 5.3 quarts + another 1.5 quarts for a total of 6.8 quarts of transmission fluid in. This is 1.3 quarts more than you wanted to put in. Won't over filling by this much cause problems in the transmission?
Greg I didn't over fill it!
In your video the large trans fluid container says “1.3 gallons” on it.
1.3 gallons = 5.2 quarts! (Check any online calculator!!)
5.2 + you added 1 full quart bottle + 1/2
(That’s 6.2 and 1/2 quarts!) 😮
My transmission is knocking hard after doing all this changes. Any idea why it is doing this
@kadeemmiddleton8373 did you put the right amount and right type of fluid in it?
Good job
@zaidaitmimi4110 Thank you!
Hey at the 14.30 minute mark I believe you said that that container of fluid is 4 gallons by mistake.
Butch Young Yes! it is!
My mother has 2015 Dodge Caravan and MPG has dropped to about 12 and 13 mpg City but Hwy it will increase up to about 18 or 19 depending on how long she drive, how can we increase the city performance, thank you,
Fitz from Rochester, NY
Fitzroy Burke does it have a check engine light on?
Check her engine air filter. If that's dirty it will drop her mpg dramatically. Easy, cheap fix.
@@juliava605multiple engine filters lol…it will be the AIR filter 👍🏻
How much does the transmission service cost 2023?
Phone send me an email at Deo@calleva.org and I will send you a quote!
do you prefer rtv over oem gaskets?
@xXxSP4RKxXx this oil pan doesn't have a gasket just RTV
Instead of dropping the pan first in order to remove the transmission fluid, why didn't you stick a rubber hose in from the top and transfer a majority of the fluid? Doing so would eliminate A LOT of potential mess all over your garage floor or driveway.
@Bill-fh5nu not necessarily when you have the right tools!
Hey I liked and subscribed I would just like to know what’s the name of the tool u using ?
@kendallscott9256 which tool?
Hello, the same amount of oil for a 2011?
@LeonardoLisboa-ce4zx I recommend you look at service info!
Très bien!
Ladeisha Williams Merci!
Nice instructions. Please reread the instructions on the RTV silicone.
@countryson6762 Thanks!
does a 3.6 take 5 quarts aswell?
Hector Boyar Yes it's pretty much the same quantity!
if the filter is that tight in the sleeve, why change the sleeve?
@rwill10282 it's recommended to replace the sleeve!
So it only take 5 and a half??
@ryanmerccer3660 quart of trans fluid?
Is this a 62TE transmission?
@RickySlatton I believe so, if I remember correctly!
Do you let it dry or not genuine question?
@gpsbando yes! you can let it dry!
@@KITS_Auto_and_Truck_Repair I put it half way on let it dry overnight I’m about to torque it now,THANKS🙏🏾💯
@@Bizzzness_not_urs My Pleasure!
Grasias
Martin Arrieta My Pleasure!!
I appreciate your Work but for me it wasn't complete ? 🤔 Because it seem like you forgot to flush the lines the one that goes to the RADIATOR those need to be Flush 👈 I m right or wrong..🤔
It was a drain and fill, not a flush. I would be very cautious doing a flush as it could dislodge something I wouldn't want flowing through the valve body.
svhebert Good question, I did a drain and fill not a flush, a flush requires draining everything including the torque converter, and there was no metal shavings in the oil pan. so when you do a drain and fill you don't have to drain the lines!
If the sleeve is that much trouble why not just leave it in there.
@rojoknight you can if you want!
He forgot to start the engine for 15 sec and switch to reverse and drive couple times before re-install the new pan and filter to force the residual old oil out of the converter.
@mohammadalsarayreh4258 you don't need to do that when you drain and fill!
@@KITS_Auto_and_Truck_Repair as a 30 years garage manger and licensed mechanic at Mercedes Berlin Germany that’s the standard. Chrysler pretty much same as Mercedes.
@@mohammadalsarayreh4258 Yes! Thanks!
now for some motor mounts lol
Hector Boyar Lol! yes we replaced the motor mounts off camera
Looks like it might need a motor mount
Gerald Wardrop Yes! we did replace the motor mounts afterwards!
не полностью заменил часть осталась в коробке
@user-hv4uo2sy4y Thanks
you should have flushed the old fluid out with 1 can of new fluid there is still old fluid in trans
@michaelbyrd2611 this is a drain and fill!