My oil pressure was going up and down and I then found oil all around my oil filter cooling housing and I replaced it and my oil pressure is still not right and when I start my car in the morning my gage says oil pressure is 80 degrees even after my car has been setting all night I failed to check out my connection real good when putting the new assembly in no check engine light has been on and it's a 2015 dodge charger se
@@jonathandeleon5588 Well My 6.0 LS with 117K its out of the vehicle on a engine stand took the oil pan off and took off the oil pickup tube to inspected the O Ring no pinches but flat around the outer edge so I put it back on again just so you know Im not reusing it but it just fell back in the hole of the oil pump with no resistance of pushing back in ,,So I bolted it down again and sprayed some soapy water on the area of the O ring and blew a little a compressed air and it was bubbling could this be the cause of a little loss of oil pressure ? Do O rings shrink over time ?
Thank you for sharing your videos. Your videos helped me tremendously.
My oil pressure was going up and down and I then found oil all around my oil filter cooling housing and I replaced it and my oil pressure is still not right and when I start my car in the morning my gage says oil pressure is 80 degrees even after my car has been setting all night I failed to check out my connection real good when putting the new assembly in no check engine light has been on and it's a 2015 dodge charger se
If my guage is bouncing in idle and while driving coupled with a ticking noise that increases with acceleration, is my engine completely done?
Sounds like a lifter
What was your problem
Great vid ,,I Notice my oil pressure goes up a little after deceleration any idea what cause that ?
Did you find out if it was your oil pressure sensor or not
@@jonathandeleon5588 Well My 6.0 LS with 117K its out of the vehicle on a engine stand took the oil pan off and took off the oil pickup tube to inspected the O Ring no pinches but flat around the outer edge so I put it back on again just so you know Im not reusing it but it just fell back in the hole of the oil pump with no resistance of pushing back in ,,So I bolted it down again and sprayed some soapy water on the area of the O ring and blew a little a compressed air and it was bubbling could this be the cause of a little loss of oil pressure ? Do O rings shrink over time ?
Great info!
How much would it cost to replace this?