I installed this on my heretic labs article 1. Right after installation my inferno is now shooting air out of the nozzle. I tried re lubing everything but nothing is working. I suspect debris was inside the new parts and fucked up my solenoid.
I try to tune the psi to 120 or above but found out even how hard I turn the regulator, the highest it can go is 110, may I ask what maybe the problem? Thanks
could this work with an AEG Jack conversion. I have a AMAZING jack set up but i want to run on gun bottles.
Thank you for that video! I bought this regulator and soon will try to install it.
for the article 2 if i set the screws for the adjustment trigger i need to disassemble the grip as well in order to remove the upper?
I installed this on my heretic labs article 1. Right after installation my inferno is now shooting air out of the nozzle. I tried re lubing everything but nothing is working. I suspect debris was inside the new parts and fucked up my solenoid.
Use o rings on the engine
@@MsProjectblue I replaced all of my orings and sprayed compressed air in the solenoid and it’s all good now.
I try to tune the psi to 120 or above but found out even how hard I turn the regulator, the highest it can go is 110, may I ask what maybe the problem? Thanks
Will it fit on a stock base wolverine mtw m4
Can you tell me how to twist the balloon correctly? Do I need to relieve the pressure somehow?
where can I buy the body or receiver?
Any suggestions if the grip line is leaking
It leaks air?
Nice!
SPEEDSOFTERS intensifies!
🤟
You gotta pull some fancy mental gymnastics if you believe that looks cool.
It's more of a performance upgrade rather than looks tbf.
Way more comfy to carry in tournaments then a normal stock
nobody asked fir ur negativity
3d seriously how tired of 3d junk that breaks from sneezing
It's molded out of the same material as many AR grips are made out of, not 3d printed. Hopefully you'll get to experience one, might surprise you.