@@hyundaitech My 2016 Veloster Turbo idle drops when parked or stopped at a red light. I've clean throttle, replaced cam sensors, purge valve, evap leak test with smoke and purge solenoid and it still does this when its warm out. No engine light either.
What if it runs great until the engine gets up to temperature then starts sputtering and won’t go past 1200 rpm? If I shut it off and re start it dose fine for a while.
I have 4 codes for my 2011 Santa fe P2106 P2110 P0638 P0391 The check engine light also turned on The problem is the while i am going in my road the petrol push not responding only for 2 rpm when i turn of the car then start it the rpm became good for a while then start the same problem again and so on
18 Hyundai Tucson limited 1.6 g4 fj new throttle body and app sensor acceleration pedal.. no throttle with cel still on, can't believe I can't delete codes unhooked battery after installing new. Code p2122
So what made you change the throttle body and accelerator pedal? Becaise of the p2122 code? Check your data for throttle angle voltage 1 and 2 and they should be equal to 5 volts for you app, check the signal wire for both app1 and app2 for short to ground hope that helps.
i have a problem P110. i replace throttle body and eventually the trouble code p110 came back again. what do you think i will do to fix it?
What code you have? After you replace the throttle body did the fault came back right away or after a while it came back?
@@hyundaitech P2110. I replace a new throttle body and after a while the code came back
I have problem with my 2015 hyundai azera to shake when i am stopped at a red light
Does it shake when you just put it in park? Looks like its misfiring. Do hear any abnormal noise or warning lights in the cluster?
@@hyundaitech My 2016 Veloster Turbo idle drops when parked or stopped at a red light. I've clean throttle, replaced cam sensors, purge valve, evap leak test with smoke and purge solenoid and it still does this when its warm out. No engine light either.
What if it runs great until the engine gets up to temperature then starts sputtering and won’t go past 1200 rpm? If I shut it off and re start it dose fine for a while.
I think you should check hows the engine temperature reads, and oxygen sensors and see what they are at. And also scan for codes.
I don’t have code
a suggestion would be appreciated blessings
Where are you from?
Toronto
bangladish
Great video.
Hi nice to meet you
I have 4 codes for my 2011 Santa fe
P2106
P2110
P0638
P0391
The check engine light also turned on
The problem is the while i am going in my road the petrol push not responding only for 2 rpm when i turn of the car then start it the rpm became good for a while then start the same problem again and so on
I dont know if the tps is built in on the throttle body on those model, if not theres a chance that the tps is not working.
18 Hyundai Tucson limited 1.6 g4 fj new throttle body and app sensor acceleration pedal.. no throttle with cel still on, can't believe I can't delete codes unhooked battery after installing new. Code p2122
So what made you change the throttle body and accelerator pedal? Becaise of the p2122 code? Check your data for throttle angle voltage 1 and 2 and they should be equal to 5 volts for you app, check the signal wire for both app1 and app2 for short to ground hope that helps.
My voltage is 12.45 is that bad?
What voltage? Where did you measure 12.45 volts?
Even you didnt know what to do bad explanation ecver