How long is the pipe to the left of the borla exhaust? That u welded in? And is it 2in pipe? And is the 45 elbow u used the 2in pipe that u cut for each side?
Sorry man I sold the machine so I don’t have the length of the pipe measurement, but it was a 2 inch pipe inlet to the muffler then a 2.5 in out pipe if I remember correctly
How long is the pipe to the left of the borla exhaust? That u welded in? And is it 2in pipe? And is the 45 elbow u used the 2in pipe that u cut for each side?
Sorry man I sold the machine so I don’t have the length of the pipe measurement, but it was a 2 inch pipe inlet to the muffler then a 2.5 in out pipe if I remember correctly
Was it super loud riding it in the woods or not to loud? Just cruising trails?
@@ericnalley4296 it’s not too bad below 5k rpm or so, but if your high throttling it, it can get pretty loud. But it sounds good to me haha
do you have the part number for borla muffler?
Did this help it idle in deep water.
Hard to say, I’ve never had issues with the machine idling under water. I would say it preforms the same
Nice
Do you have to weld it, or can you use an exhaust clamp
Welded
Are you clearing 14in rims?
Yes but I had to put 1 inch wheel spacers on the rear so that way the upper control arm knuckle didn’t rub the rim.
Have to do any tuning?
Nope
You loose any power? Plan on doing the same thing
No I didn’t notice power loss, if anything I think It gave it a little more pep in the step haha
What diameter in and out did you get? I got to have one.
I believe it was 2 inch in, and 2.5 out
Holy shit that's loud