The Expert's Guide On How To Make Homemade Sculpting Paste

แชร์
ฝัง
  • เผยแพร่เมื่อ 23 ธ.ค. 2024

ความคิดเห็น • 61

  • @hebe935
    @hebe935 ปีที่แล้ว +11

    Thank you for the recipe! I’m not sure if you know this tip; but an easier and cleaner way to load your piping bag is to sit the bag in a cup, tip first. Then open the bag over the sides of the cup, Pull them down until you are closer to the tip end of the bag. Fill your bag. Then just pull the sides of the bag up off the outside. I hope this makes sense lol.

  • @meloneyreagle2438
    @meloneyreagle2438 ปีที่แล้ว +2

    Thank you, your are amazing at what you do. I have a suggestion, mix all the ingredients in a plastic ziplock bag. You can either put the tip on that or slip it in your piping bag. Easier clean up

  • @mdosmangani6438
    @mdosmangani6438 ปีที่แล้ว +2

    Thanks a lot this is exactly what I have been searching

  • @jasminechenoweth4809
    @jasminechenoweth4809 5 หลายเดือนก่อน +3

    Can I ask what the Powder is? So excited to try this.

  • @lovelifeloveyourself9870
    @lovelifeloveyourself9870 8 หลายเดือนก่อน

    Thank for a simple recipe. Great job and thanks for sharing.

  • @doublybubblysoap9734
    @doublybubblysoap9734 ปีที่แล้ว +1

    Thank you, Steve!!! This looks like it would be good for minor sheet rock repair too! So many uses to think about trying!!

  • @libbyannbest1723
    @libbyannbest1723 ปีที่แล้ว +1

    Can I substitute gypsum/plaster instead of joint compound?

  • @christinaperson1168
    @christinaperson1168 ปีที่แล้ว +1

    Wow, that is awesome! I will definitely be trying this out. Not sure what for yet, but they'll be ready when I figure it out. Thank you Steve 😊!!!

  • @ViKee010
    @ViKee010 8 หลายเดือนก่อน +1

    So pretty. A little opal glitter sprinkled over the top of this white would be nice I bet. Thank you Steve. ✌🏻🤍

  • @sweetolie1
    @sweetolie1 ปีที่แล้ว +1

    I use the same wet mixture in my cement sculptures. I LOVE it and you are correct, so much more convenient ! Hugs

    • @mariawilson2595
      @mariawilson2595 7 หลายเดือนก่อน

      Really ? are the sculptures for outside or in xxxx

  • @elenavaccaro339
    @elenavaccaro339 ปีที่แล้ว

    Oooohhhhh!!!! Terrific!!!
    Can I make a suggestion?
    A silicone spatula or scraper like used in the kitchen will make getting all of your paste out of the bowl.

  • @klairbaranek
    @klairbaranek ปีที่แล้ว +1

    Can’t wait to try this out 😊

  • @cyn7869
    @cyn7869 ปีที่แล้ว +1

    This is a great recipe Steve! Thanks for sharing it. I will be trying it very soon.👍❤️

  • @naudiaangelica6925
    @naudiaangelica6925 ปีที่แล้ว +2

    Thank you for the recipe! Have you tried lightweight spackling? It works very well for exactly this. I like it because it comes out pink, and turns white as it dries, so you know when it's dry :-)

  • @stepintoart1668
    @stepintoart1668 ปีที่แล้ว +1

    What is joint compound in Australia please

  • @LisaVornhagen
    @LisaVornhagen ปีที่แล้ว

    That's pretty cool! Can't wait to see what you are going to do with them!

  • @tracyharper2121
    @tracyharper2121 ปีที่แล้ว +3

    Iced gem sweeties!!! Remember those????❤

  • @42710steph
    @42710steph ปีที่แล้ว

    Thank you for sharing Steve ! I will definitely try this 👍

  • @carriannef1691
    @carriannef1691 ปีที่แล้ว

    Use the Russian piping tips, they’re brilliant for making flowers 🌸

  • @lindarugan7962
    @lindarugan7962 11 หลายเดือนก่อน

    Can l use joint compound in paste instead of powder?
    Thank you so very much for sharing! ❤

  • @patsyhune6329
    @patsyhune6329 4 หลายเดือนก่อน

    What is measurement on shot glass ?
    Love your work steven...

  • @VibinRavi
    @VibinRavi 22 วันที่ผ่านมา

    Hey,can I use talcum powder or cornflour instead??

  • @ShellsSpace_MyEndobattle
    @ShellsSpace_MyEndobattle ปีที่แล้ว

    They look like iced gems ❤

  • @soledude
    @soledude ปีที่แล้ว +2

    Great recipe from the looks of it. 👌👌👌
    I can’t find that exact patch paste though. Is there some special quality I need to make sure the plaster I find also have or is it just wall patching paste in general that does the job?

    • @HO-bndk
      @HO-bndk 9 หลายเดือนก่อน +2

      The powder is just a bulking agent. You can use talcum powder (baby powder) instead.

    • @soledude
      @soledude 9 หลายเดือนก่อน

      @@HO-bndk oh, ok. Thanks. 👍

  • @lindaeastment4542
    @lindaeastment4542 ปีที่แล้ว

    Hi Steve, I would just like to say a very big thank you your Inspiration for crafty things just keep getting better & better 👍 good on you ✨ Steve, If you pipe your sculpting paste onto a Silicon mat would that make It easier to remove your work ✨❤️👍

  • @lindafreudiger8022
    @lindafreudiger8022 11 หลายเดือนก่อน +1

    Is there a difference between textured paste and sculpting paste?

  • @Timeline007-tl
    @Timeline007-tl 2 หลายเดือนก่อน +1

    What is the powder ???

  • @dollybrown1993
    @dollybrown1993 ปีที่แล้ว

    I decorated cakes many years ago and I will say it is a skill set that takes some practice.... this looks like it will take a bit to get the results you are trying to get.
    We would just put it on the board and scrape it off until we learned to do the different designs.
    Can't wait to get started on this. It looks like so much fun.
    Once it's fully dry I would think that you could make a mold of it and then use the design to make with resin.... Is that possible??
    Love to the family and fur babies 💞
    Stay safe, you do you, and stay crafty 👍👍🛎️🔔🦋🦋

  • @TheMorgan48612
    @TheMorgan48612 ปีที่แล้ว

    More great ideas

  • @patriciaharkin1571
    @patriciaharkin1571 ปีที่แล้ว +8

    Like the results but I'm confused. You said the ratio was 50% water, 25% paint and 25% glue which should mean 6 shot glasses water, 3 of paint and 3 of glue but you only used one and a half of paint. Can you verify which ratio is correct please?

    • @dianeh2420
      @dianeh2420 ปีที่แล้ว +2

      Steve, could you also say: 6oz water, 3 oz of paint, 3 oz glue??

    • @patriciaharkin1571
      @patriciaharkin1571 ปีที่แล้ว

      @@SteveMcDonaldArtsandCrafts Ok, thanks for that.

    • @biancaj2311
      @biancaj2311 ปีที่แล้ว +1

      ​@@dianeh2420 no it's 6oz water 1½oz paint 1½ glue

  • @manisha-colorcreativityartwork
    @manisha-colorcreativityartwork 4 หลายเดือนก่อน

    Hi. After water and acrylic paint, did you put glue in it too ? it was not shown in the video... then how much of the glue in it ?

  • @NinaNino2016
    @NinaNino2016 5 หลายเดือนก่อน

    Joint compound es yeso?

  • @dpro7445
    @dpro7445 ปีที่แล้ว

    Thank you!!

  • @harleypetrovsky1903
    @harleypetrovsky1903 7 หลายเดือนก่อน

    Instead of white paint we can use whatever color we will use right?

  • @mariawilson2595
    @mariawilson2595 7 หลายเดือนก่อน

    Steve ... thanks is it or cn it be waterproof please ? I want to cover an armature with it x

  • @sandrahitchcock2146
    @sandrahitchcock2146 ปีที่แล้ว

    Hi Steve, could you use this to shape a mould or would it react to the resin? Thank you, great idea as usual. 😊😊

  • @mahawaqas2646
    @mahawaqas2646 3 หลายเดือนก่อน

    What is joint compund?

  • @FirebladeCBR
    @FirebladeCBR ปีที่แล้ว +1

    How do you clean out the bag, piping tip & coupler?

  • @klartistic
    @klartistic ปีที่แล้ว

    Great video. Can I ask what joint compound is ? I’m in Australia 🇦🇺

  • @TL-pk6jl
    @TL-pk6jl ปีที่แล้ว +1

    Thank you so much. This is exactly what I needed for a project I want to finish. So many fails... And as Always... You answered questions I did not ask. You are awesome!

  • @peterklippare
    @peterklippare ปีที่แล้ว

    Hi Steve! Have you tried to combine resin and concrete in the same mold? Half and half… Letting one set before you pore the next, is it possible you think?

    • @Momnpop98
      @Momnpop98 ปีที่แล้ว

      It is possible. I've seen another TH-camr use a faceted diamond mold with cement first then topped with resin to make pendants.

  • @Camicamelia123
    @Camicamelia123 3 หลายเดือนก่อน

    Pot folosi pe pînză pasta

  • @1525kat
    @1525kat ปีที่แล้ว

    Tip put your piping bag in a jar with bag pulled out over rim. Now scoop the mix into the bag. When you pull the bag ends up, all the goop is down at the nozzle rather than all over the bag and wasted. (That's what decorators do).

  • @beaswingle9065
    @beaswingle9065 6 หลายเดือนก่อน +1

    How come you don’t pip that on wax paper that works very well and I love your ideas ❤❤❤

  • @familyleap2071
    @familyleap2071 8 หลายเดือนก่อน +1

    Not cracking?

  • @arianrhod
    @arianrhod ปีที่แล้ว

    Like making icing for a cake.

  • @Camicamelia123
    @Camicamelia123 4 หลายเดือนก่อน +1

    Rețeta vă rog

  • @dianeh2420
    @dianeh2420 ปีที่แล้ว

    Steve, could you also say:
    6oz Water
    3oz Acrylic paint
    3oz White glue
    Enough powdered plaster to make pate so you can put in piping bag to make designs
    ??? Does that make sense? 🥺🥴❤️🙏💯

  • @RD9_Designs
    @RD9_Designs ปีที่แล้ว +2

    Your maths are off. If 50% is 6 shot glasses, 25% is 3 shot glasses.

  • @MostGratefulOwl
    @MostGratefulOwl 11 หลายเดือนก่อน

    Those clorox bleach pens for tiles arent made anymore but there is a recipe to make it yourself... Its fun for drawing stuff on clothes.

  • @Sani-c1s
    @Sani-c1s ปีที่แล้ว +1

    why aren't there more languages ​​for us to understand. everything in English

  • @mandicoleman7433
    @mandicoleman7433 ปีที่แล้ว

    Those r cute mine would look like 💩💩💩 😂😂😂