Suzuki Swift Clunking Noise From Front Suspension. Lower Ball joint Replacement

แชร์
ฝัง
  • เผยแพร่เมื่อ 21 ต.ค. 2024

ความคิดเห็น • 17

  • @davesterl
    @davesterl  3 ปีที่แล้ว

    Find the items that are used on the Dave Sterl channel in the Amazon shop.
    www.amazon.co.uk/shop/davesterl

  • @tommattmonty
    @tommattmonty 4 ปีที่แล้ว

    Doing this to mine soon, thanks for taking the time to film it

  • @gingerjessy
    @gingerjessy 6 หลายเดือนก่อน

    That third hand is pretty good design. I've been wanting someone to give me a hand for twenty years.😂

  • @CarsExposed
    @CarsExposed 5 ปีที่แล้ว

    Top job mate that old ball joint was knackered 😬👍👍👍

    • @davesterl
      @davesterl  5 ปีที่แล้ว

      aye, bad one that igor. easy to find tho. cheers dave

  • @drosser8461
    @drosser8461 2 ปีที่แล้ว

    That's a solid looking G clamp - I can't find one online - any idea who sells them.

  • @bluemini17
    @bluemini17 5 ปีที่แล้ว

    Great video Dave.

  • @TheGibby3340
    @TheGibby3340 5 ปีที่แล้ว

    Ahhh... a rare big “S” appearance on the channel ! “Torque Police”😂 Cheers Pal

    • @davesterl
      @davesterl  5 ปีที่แล้ว

      awwwh, i thought you would like this one ian

  • @RATTLEJAKEGAMING
    @RATTLEJAKEGAMING 4 ปีที่แล้ว +1

    How much would this cost to have done?

  • @avinashsinghrawat3620
    @avinashsinghrawat3620 2 ปีที่แล้ว

    Hi Sir,
    I am from.india
    I have 2WD Suzuki Dzire Vehicle MT version.
    I had a issue in my 1000km run new car.
    When i start engine and turn electric power steering left side approx 10deg it make knock noise.
    Then while driving its not there.
    Then again whenever car shutdown and start after 30min this knock sound comes when steering turn left at 10deg in engine idle and wheel stationary ( On both Plain and semi plain floor ) and its not sound of tyres and steering or floor.
    Plz guide

  • @robindeleon2640
    @robindeleon2640 3 ปีที่แล้ว

    Tightening torque 43.5 lb-ft

  • @dappa211
    @dappa211 4 ปีที่แล้ว +2

    Using an air hammer to remove the Ball joint is just a waste of effort. The control arm is designed to push the ball joint up into the spindle and stay up. Use the appropriate tool for the appropriate job

    • @davesterl
      @davesterl  4 ปีที่แล้ว +4

      What are you on about

  • @Sjobom7715
    @Sjobom7715 ปีที่แล้ว

    👍👍🌟🌟🤗

  • @Kingstersreejit
    @Kingstersreejit 4 ปีที่แล้ว

    Speak louder all of us may not use headphones