Vented valve cover no weld
ฝัง
- เผยแพร่เมื่อ 5 ก.ย. 2024
- In this Video i show you how to add -10 fittings to your K24 Valve cover.
So you can add a Catch can setup.
This is a no Weld technic that can also be used on othere similier valve covers.
This is for my K24 swapped frs
10 an to 3/8 NPT fitting
amzn.to/3smUCu6
10an to 10 on Bulkhead fitting
amzn.to/3LjyUjm
3/8" Carbon Steel NPT Pipe Tap and 37/64" High Speed Steel Drill Bit
amzn.to/3gtJ1nl
For more content like this Check out my channel ►
www.youtube.co...
Follow me on Instagram ► / trip_skywalker
My gear ►
Sony SV -1: amzn.to/34BPebf
Gopro hero 7 black: amzn.to/2KRCG5u
Gopro 3.5 mic adapter: amzn.to/2KS59ba
Rode compact mic: amzn.to/3bXJJWi
DJI Mavic pro: amzn.to/2zLNFuR
#k24 #ventedvalvecover #trip
Just a small tip, you are NOT suppose to bottom the NPT fitting out. You are only suppose to thread enough that the fitting can thread in because you need the pipe fittings to be very tight against each other. You then use thread sealant or teflon tape on the threads. These were installed incorrectly.
Great work Trip
Thanks man
This is great to know thanks for information
I was thinking about welding mine in, but looks like I’ll be doing this instead!
Pretty neat. I wouldn’t have used a pipe tread fitting but it will still get the job done. Any word on the adapter plate?
For your 10an fitting what self tapping thread size did you need?
Very cool
looks good should work nice
Shouldn't you use a crush washer?
It wouldn't hurt. But might be hard to find the correct size you need.
apparently you dont know how fun Tig welding is.
Most of us can't afford a TiG