It was fun to work this video out because I like it when plans work. Thanks to many good comments in the last video I got the right tool to succeed (even if I had to "change" it little bit as always). I hope you enjoyed this video.
HI, I'm looking to buy the same set of Bearing removers and was just wondering if you could tell me the size of the hole ( or what size puller you used and grounded down ) of the Bearing that remained inside the frame, Thanks Malcolm.
@@malcolmnash5850 hey, I ordered the set with different sizes bc it's very useful anyway. If you want to buy this specific size only I can measure it for you.
It was fun to work this video out because I like it when plans work. Thanks to many good comments in the last video I got the right tool to succeed (even if I had to "change" it little bit as always). I hope you enjoyed this video.
8:09 The "Aaachhhhh" came from deep within, I felt that :'D
:D one hand holding parts and something falls down...
What was the inner race puller tool? Thanks!
A cheap set off ebay
Hi, how did you remove the and replace the bearings on the Triple Clamp, Thanks Malcolm.
Hi, see this earlier video
th-cam.com/video/YC8nonjfdLA/w-d-xo.html
Thanks very much for the information and help.
HI, I'm looking to buy the same set of Bearing removers and was just wondering if you could tell me the size of the hole ( or what size puller you used and grounded down ) of the Bearing that remained inside the frame, Thanks Malcolm.
@@malcolmnash5850 hey, I ordered the set with different sizes bc it's very useful anyway. If you want to buy this specific size only I can measure it for you.
Thanks, I'm also going to buy a set but I would like to know that the right size is amongst it, Thanks Malcolm.
When installing bearings or other metals it helps to soak the bearing in the freezer for six to twelve hours.
Thanks, good tip especially for bigger parts