Excellent video perhaps You should look into 3D printing a firearm. Hoffman tacticals Orca build would probably be pretty challenging and a lot of fun to complete. You should look into it.
@@PhDarien My P80s magazine release button was too tall. I shortened it with a Dremel so my thumb doesn't touch it, except when I actually want it to. Did a fiber optic front sight too. I used a Gllock slide and barrel I found cheap on Ebay. It works perfectly. However, both the Glock and the P80 throw brass at the face of whoever shoots them. I changed the extractors but they still do that. Endemic to the design. None of my other 9mms do that, but the Lugers are fond of dropping hot brass down the back of my neck. :)
@@PhDarien ok. I started out using a Craftsman monster that I had bought for making cabinet doors with but it was a bit unwieldy. Then I bought a smaller laminate router from Ryobi. I will be trying it out on my next lower
I’ve got 3 routers and the other two are from Ryobi. I may do a garage walkthrough one day and post it for people to see what tools a use for what I do.
#FreedomIsntFree🇺🇸🚫
#LibertyWithResponsibility🇺🇸💯
Excellent video perhaps You should look into 3D printing a firearm. Hoffman tacticals Orca build would probably be pretty challenging and a lot of fun to complete. You should look into it.
Funny how you mention this. I started out yesterday looking for some
Only serialized lower I have is an SBR. Serial required for tax stamp.
I thought about getting one for that reason
I have a Glock, but I like my P80 knock off more. :)
I hate mine so far
@@PhDarien My P80s magazine release button was too tall. I shortened it with a Dremel so my thumb doesn't touch it, except when I actually want it to. Did a fiber optic front sight too. I used a Gllock slide and barrel I found cheap on Ebay. It works perfectly. However, both the Glock and the P80 throw brass at the face of whoever shoots them. I changed the extractors but they still do that. Endemic to the design. None of my other 9mms do that, but the Lugers are fond of dropping hot brass down the back of my neck. :)
Good video!
How much more in the academy do you have left, and good luck as a LEO!
6 weeks
What router do you use when cutting out your lowers?
I use the Dewalt DWP611
@@PhDarien ok. I started out using a Craftsman monster that I had bought for making cabinet doors with but it was a bit unwieldy. Then I bought a smaller laminate router from Ryobi. I will be trying it out on my next lower
I’ve got 3 routers and the other two are from Ryobi. I may do a garage walkthrough one day and post it for people to see what tools a use for what I do.
@@PhDarien that would be cool. IIRC, the Ryobi I bought is probably a rebranded DeWalt. I think it uses the same batteries as my DeWalts use
That’s wild.