Iron Will Broadhead Main Blade Alignment

In this video you will learn how to properly align the main blade of your Iron Will Broadheads.
Loosen the T6 screw just slightly so that the blade can be pushed side to side. Adjusting the blade too far to one direction can be seen when rotating the broadhead 180º over the line. When properly aligned, the point should stay on the line when rotated back and forth 180 degrees.
You are now ready to tighten down the main blade. Pushing the main blade back into the ferrule when tightening the screw so that the bleeder is secured and not loose.
Recheck the alignment of the broadhead once tightened to make sure nothing had moved during the process.
Once aligned you are ready to go hunting!
T-6 Torx Driver
ironwilloutfitters.com/collec...
Blade Care Kit
ironwilloutfitters.com/collec...
Replacement Blades
ironwilloutfitters.com/collec...

[@alexgrier9869]

This is especially critical with the wide heads.

[@STIHLFIRE437]

After listening to your videos with MFJJ and Dan from Elkshape. I’ve decided to run all iron will components for 2024. Thank you so much for all the great videos and information Bill. Keep up the great work!

[@bassamaticfpv4354]

Good stuff !