REMOVING UPPER INTAKE MANIFOLD ON AN AUDI 3.2 V6

REMOVING UPPER INTAKE MANIFOLD ON AN AUDI 3.2 V6
If you would like to help support this channel please take a look at these tools I recommend and use daily.
Streamlight usb rechargeable pen light (affiliate link) amzn.to/3GxgWtl
Automatic noise cancelling ear protection (affiliate link) amzn.to/3Q7ZiPZ
Reasonably priced metric wrench set. (affiliate link) amzn.to/3GvIkHV
Excellent 1/2in drive split beam torque wrench (same as snap on) (affiliate link) amzn.to/3Z5qu67
Thank you and thanks for watching

[@vinividivici3]

Thank you for this informative video. I will need to remove mine to repair a lot leaks and do some carbon cleaning so this helps a lot. One of my faults is a P2070 fault which is a stuck open air intake valve. I was trying to look for a vacuum lever actuator which wears out that pulls the intake valves by the intake runners but I dont see them. I have seen videos of this on the B7 3.2L but my engine (B8) does not. Does the B8 use a different mechanism? Thank you

[@EuropeanAutoRepair]

Does your car have the supercharged 3.0tfsi?

[@vinividivici3]

@@EuropeanAutoRepair No, it is the 3.2L FSI V6 (CALA), same as in this video.

[@EuropeanAutoRepair]

On bank 1 is off the front on passenger side, they are mounted on lower intake manifold, I’ve seen some of those that actually don’t have those flaps but I’m unsure which that is

[@aster5031]

10/10

[@EuropeanAutoRepair]

Thanks!