Squarebody LS swap DIY standalone wiring harness

[@Logandary8D]

That’s a dope swap

[@cwsgarage]

I appreciate that! It’s coming along!

[@jeffvita6633]

Nice!

[@cwsgarage]

Thanks Vita!

[@tareese78]

Ok no joke but how can I get in contact with you to help with my obs swap

[@cwsgarage]

I haven’t don’t any OBS stuff honestly. Not sure how much I could help lol

[@jayball1324]

What engine is this and what harness you running

[@cwsgarage]

It’s a 2000 5.3 DBC, I built the harness and bought the fuse/relay setup from current performance.

[@quentinstadler]

What fuse block did you use

[@cwsgarage]

www.currentperformance.com/shop/stand-alone-fuserelay-module/

[@matthewkramer5447]

I'm going to attempt this on a 83 k5 motor is in and runs like shit , painless wire harness time

[@cwsgarage]

Is it throwing any codes? Make sure you have adequate grounds, it’s easy to get some of the wires in the wrong spot on the ECU pin out if you cleaned up the stock harness.

[@user-nl2qp5iz9v]

Was it hard to rewire

[@cwsgarage]

It wasn't easy, it gets a little easier the more you do it. A lot of reading and referencing wiring info on LT1swap.com