YAESU FT-710 After Firmware Update v01-06(Perform Reset Once Completed)

patreon.com/M0FXBHAMRADIODIARY (Perform Reset Once Completed) • YAESU FT-710 Factory R...
YAESU FILES SECTION
www.yaesu.com/....
FIRMWARE
www.yaesu.com/....
INSTRUCTIONS
www.yaesu.com/....
USB DRIVER
www.yaesu.com/....
CHANGELOG
[FT-710_Firmware_update_202211]zip Contains:
• MAIN: V01-06 /FT-710_MAIN_V0106.SFL 11/14/22 (New)
• DISPLAY: V01-05 /FT-710_DISPLAY_V0105.SFL 11/14/22 (New)
• DSP: V01-00 /FT-710_IFDSP_V0100.SFL
• SDR: V01-03 /FT-710_SDR_V0103.SFL
• Firmware_Ver_Up_Manual_ENG_FT-710_2211A 11/14/22
Implements improvements:
1. Fixed a bug that "Key up" noise appeared when operating in CW mode on 28MHz band.
2. Fixed the problem that COM Port Baud-rate becomes 4800bps when power is turned ON with
"PRESET" ON.
3. Fixed a bug that sometimes-prevented transmission when a linear amplifier (VL-1000) is
connected.
4. Fixed a problem that continuous operation or hang-up may occur
when playing/rewinding/forwarding recorded data while receiving a signal.
5. Optimized variable volume and minimum headphone volume when turning VOL knob.
6. Fixed a bug that caused a delay when an external CW KEYER is connected.
7. Fixed the problem that CW transmission may not be possible with the straight key.
8. Fixed a bug that CW does not work properly when "BUG KEY" is selected in
"KEYER TYPE".
9. Fixed a bug that PC KEYING did not work partially in CW mode and CW AUTO mode.
10. Fixed a bug where changing the Baud-rate of COM Port is not reflected correctly.
11. Other improvements and optimizations have been made.

[@davidpiper3652]

You need to do a full reset after the upgrade according to the instructions. This fixed the comm port issues and cw problems I was getting. I concur on the function button and a mouse.

[@HamTechRadioScannerDrones]

Thanks for watching yes have done a reset

[@cw2gtc]

You could add an external USB hub. To plug in more USB gadgetry, no?

[@HamTechRadioScannerDrones]

Not really

[@AliReza-zx8km]

Nice..................

[@HamTechRadioScannerDrones]

Thanks

[@kylek3377]

Is there a MARS mod for Yaesu FT-710 where you bridge a connection on the PCB to enable out-of-band transmission?

[@HamTechRadioScannerDrones]

Not yet

[@donalfinn4205]

Can you explain to me please the set up with the power meter? Normally, it’s at zero more or less until you key up and it should show power. My 710 seems to be working in reverse! When I key up it goes to zero? I am subbed of course .Thanks. EI3KY

[@HamTechRadioScannerDrones]

Hi if the swr is high the Radio will reduce the power.