Watch the bed warp test starting at 4:57 - I found this to be very eye opening. Especially the later part of the test that I did not notice until I watched the time-lapse. This test was over 30minutes in length and what it shows it that with the OEM heater, the bed is NEVER level and also the bed is NEVER the same, even well into a print.
I Can't really link directly to the parts as the Aliexpress vendor must know the correct voltage for your setup and the other two parts are just on Amazon. Do a search, you'll find them. The exact ones I purchased do not seem to be listed anymore. Thanks for watching!
@@JimmiFriborg Sorry, the links for the exact parts I ordered are not active anymore. I have had these parts for a long time and just didn't have time to install them while filming. On Amazon, search for AC110V 4000W Regulator. Good luck!
Watch the bed warp test starting at 4:57 - I found this to be very eye opening. Especially the later part of the test that I did not notice until I watched the time-lapse. This test was over 30minutes in length and what it shows it that with the OEM heater, the bed is NEVER level and also the bed is NEVER the same, even well into a print.
I have the same heater mounted on my Wanhao D9 500 now, it works awesome. Also success with ABS now :0)
Very nice! Thanks for watching!
Would you mind linking to the parts? ☺️
I Can't really link directly to the parts as the Aliexpress vendor must know the correct voltage for your setup and the other two parts are just on Amazon. Do a search, you'll find them. The exact ones I purchased do not seem to be listed anymore. Thanks for watching!
@@Grimm3D I actually have the bed, it's more the regulator I'm curious about 😁
@@JimmiFriborg Sorry, the links for the exact parts I ordered are not active anymore. I have had these parts for a long time and just didn't have time to install them while filming. On Amazon, search for AC110V 4000W Regulator. Good luck!