Hey I just changed my transmission filter on a 1999 Isuzu Amigo, and there is no need to take the crossbar off. all you need is a swivel socket with an extension, and a 10 mm wrench, with that you can reach behind the crossbar and undo those bolts.
I just replace the trans fluid and filter on my 2002 Isuzu rodeo sport and I had NO problem dropping the pan without removing the cross member. Now that I think of it, did the same on my 1998 rodeo 16 years ago.
@William Perri defiantly change the trans oil AND filter, should take care of the problem. there is a small trans oil pan just in front of the main one that needs to be drained at the same time to get all the gunk out of the oil. no need to do it again after a month, just dropping both pans and replacing the filter will be good. I do mine every 50 thousand miles.
@William Perri Try some Marvel Mystery oil in gas tank. Follow directions. Will help clean fuel system and injectors. At every fuel up for a month and then once a month afterwards to keep everything clean. Worked for my Sorento. Am getting a passport so watching maintenance videos. Good luck.
This is def an involved process and thanks to Matt we now have a comprehensive method. Make yourself comfy because these 2 vids will probs save you ~$300 in shop labor.
I have a 2001 Honda Passport. The fill plug is next to the drain plug I think. I used this and the fluid did not come back out, but then the trans was very low. Does that sound right?
Im going to attempt restoring my 1992 Rodeo bougjt new, V6, automatic 4wheel chassis, approx 150k miles, faded but not rusted. Where to begin, I have no idea where to start first!? Does not start.
I had my transmission rebuilt and it started slipping a few months later. Fluid was low. I topped off with 1 qt of Mercon V, will this be a problem? I assume they used Dexron
Had some fun with mine yesterday changed out the radiator because it cracked. Got a duralast radiator and it was broken but wasn’t able to tell. Long story short transmission fluid was filling in the coolant system lost a good 3 quarts of trans fluid. Changed the radiator to carquest today and flushed the system and drained and filled the fluid in the trans . Only accepted 4 quarts now it’s slipping
How do you remove the 10mm nuts off the bolt, if for instance the nut spins but doesn't move up or down on the bolt??? I'm freaking out! Thought perhaps I could bypass them, there is another plate blocking two nuts on the pan, and 2 14mm bolts holding that in place. Looks like that plate is also holding up the cross member. (Mine is a 1999 rodeo) Got it down to a point where now my ratchet and socket are stuck between the bolt and the cross member....FML
Definitely pull the inner bolts FIRST on the cross member that connect to the trans, then the outer bolts. I snapped the bolt heads off trying to take mine out... Kinda screwed
tks for the video Matt. I tell ya, some of this auto mrg should be in JAIL beside dishonest greedy food chains... for making this where one is forced to take cars to dealership to fix who charge ungodly fees. its really criminal. 1000 ways they could design to put transmission fluid in, but they CHOOSE to do it hardcore on purpose.
I really hate the design of the zoozoo transmission well I guess it's not really an Isuzu transmission a lot of vehicles use them. But just simply putting new fluid in it or topping it off as a pain in the butt.
Thanks so much! It's definitely tricky trying to film with one hand and "do" with the other while crawling around under a vehicle that's not raised off of the ground! Thanks for watching!
That's so stupid there's no dipstick. I mean this is a pain in the ass, messy, and costly. Why couldn't they just make it so you add the quart like the oil does? If you are disabled you gotta pay a high cost for a shop to do it. These vehicles require way too much maintenance compared to jeeps.
Very helpful video, thank you. 🙂
The transmission doesn't come with a dipstick because it was designed by a dipstick. 😠
He probably worked at BMW too, they being the ultimate added an idiot light
Hey I just changed my transmission filter on a 1999 Isuzu Amigo, and there is no need to take the crossbar off. all you need is a swivel socket with an extension, and a 10 mm wrench, with that you can reach behind the crossbar and undo those bolts.
This comment right here needs to be pinned, also a video demonstration would be lovely
It must be different on a Rodeo. There's one bolt that is not accessible with a swivel socket
@@nicholascarter7491 yes but a 10mm wrench will work
@@nicholascarter7491 it’s very different w a rodeo , u cannot use a wrench to get to the bolts
I just replace the trans fluid and filter on my 2002 Isuzu rodeo sport and I had NO problem dropping the pan without removing the cross member. Now that I think of it, did the same on my 1998 rodeo 16 years ago.
@William Perri defiantly change the trans oil AND filter, should take care of the problem. there is a small trans oil pan just in front of the main one that needs to be drained at the same time to get all the gunk out of the oil. no need to do it again after a month, just dropping both pans and replacing the filter will be good. I do mine every 50 thousand miles.
@William Perri Try some Marvel Mystery oil in gas tank. Follow directions. Will help clean fuel system and injectors. At every fuel up for a month and then once a month afterwards to keep everything clean. Worked for my Sorento. Am getting a passport so watching maintenance videos. Good luck.
please elaborate on ur most astonishing find
Thank you for this information! I just bought an 04 rodeo with over 200k and plan to be doing this soon
Thanks you helped out alot bud had to change this on my mom's vehicle
6:30 for bolt removal sequence - kinda. Do inside bolts first with trans jacked up
Is this the 4L30-E? I'm trying to figure if this process will apply to my '98 Trooper...
This is def an involved process and thanks to Matt we now have a comprehensive method. Make yourself comfy because these 2 vids will probs save you ~$300 in shop labor.
I have a 2001 Honda Passport. The fill plug is next to the drain plug I think. I used this and the fluid did not come back out, but then the trans was very low. Does that sound right?
My 03 rodeo, 156k miles… has never had the transmission fluid replaced. Is there any concern that changing it Now would cause issues w tran now?
Im going to attempt restoring my 1992 Rodeo bougjt new, V6, automatic 4wheel chassis, approx 150k miles, faded but not rusted. Where to begin, I have no idea where to start first!? Does not start.
I had my transmission rebuilt and it started slipping a few months later. Fluid was low. I topped off with 1 qt of Mercon V, will this be a problem? I assume they used Dexron
Had some fun with mine yesterday changed out the radiator because it cracked. Got a duralast radiator and it was broken but wasn’t able to tell. Long story short transmission fluid was filling in the coolant system lost a good 3 quarts of trans fluid. Changed the radiator to carquest today and flushed the system and drained and filled the fluid in the trans . Only accepted 4 quarts now it’s slipping
My Isuzu Rodeo is 2-whel drive (has no transfer case) so I dont need to support anything when I remove that cross member?
Right?
Where do i put a jack to hold the trans if i dont have a 4wd? On the driveshaft?
How do you remove the 10mm nuts off the bolt, if for instance the nut spins but doesn't move up or down on the bolt??? I'm freaking out! Thought perhaps I could bypass them, there is another plate blocking two nuts on the pan, and 2 14mm bolts holding that in place. Looks like that plate is also holding up the cross member. (Mine is a 1999 rodeo) Got it down to a point where now my ratchet and socket are stuck between the bolt and the cross member....FML
Same problem, bracket nuts spin but won't loosen and actually won't tighten now either. I've tried everything....I'm confused.
Just try to get an extension socket/swivel for those and don't even remove the bracket
how do I change a transmission fluid hose on this same vehicle?
Little trick. play it at 1.5x speed and its less time consuming
Double speed only option
Definitely pull the inner bolts FIRST on the cross member that connect to the trans, then the outer bolts. I snapped the bolt heads off trying to take mine out... Kinda screwed
Hey dude. I know this is a long shot but do you know the size of those bolts? We've snapped the exact ones and are trying to find a replacement
Where did you buy the filter?
Is it MANDATORY to drain the small drain pan at 9:34? I just drained the main one
Does this apply for a 98 3.2 5 speed?
What type fluid does it use
Does anyone know if the cross member needs to be removed on a 2000 trooper ?
it's the same setup as shown 4l30e. it's up to you if you can get a socket up there.
No need!
Did you run the overdrive housing dry when u installed and just topped it off or did u try to not spill
tks for the video Matt. I tell ya, some of this auto mrg should be in JAIL beside dishonest greedy food chains... for making this where one is forced to take cars to dealership to fix who charge ungodly fees. its really criminal. 1000 ways they could design to put transmission fluid in, but they CHOOSE to do it hardcore on purpose.
So true!!
How much does the transmission sag once the crossmember is removed?
It shouldn't sag at all.
Thank you Matt for making this video, I own a rodeo too and this really helped me so I subscribed to your channel, thank u brother👍
What engine is this? 4JX1??
Hey I own a rodeo please help me check trans what appen please
Thanks for the video, and NOT for answering people!
I really hate the design of the zoozoo transmission well I guess it's not really an Isuzu transmission a lot of vehicles use them.
But just simply putting new fluid in it or topping it off as a pain in the butt.
Great video man! Footage looks clear under vehicle. Not easy to do.
Thanks so much! It's definitely tricky trying to film with one hand and "do" with the other while crawling around under a vehicle that's not raised off of the ground!
Thanks for watching!
@@mattpayne4087 how did the 10mm bracket nuts come off....great video but you skipped that part
@@44ablemonk lol thats why u have to go to school they not gonna show you the whole process lol
Is this transmission reliable?
yes
buen trabajo
do NOT have to remove cross member...
Hell yeah
Your transmission plugs are leaky! You need to get new gasket washers!
That's so stupid there's no dipstick. I mean this is a pain in the ass, messy, and costly. Why couldn't they just make it so you add the quart like the oil does?
If you are disabled you gotta pay a high cost for a shop to do it. These vehicles require way too much maintenance compared to jeeps.
You talk to much