Losi Mini B Aluminum Steering Build
ฝัง
- เผยแพร่เมื่อ 12 ธ.ค. 2021
- Build in once, build it right! Just let it rest a bit before you install into car and drive around...let that thread lock set up a piece.
Two things to remember.
1) Thread lock on draglink threads from the backside to prevent anything getting locked but the threads.
2) Let the thread lock set up a little, then make the final adjustment of kingpin tightness...then let it rest for a few.
I've been all over looking for a video about this because my experience with my mini one of the screws would come out time to time on the track. I was hesitant about threat lock but you answered my question! Thank you!
But it's prominently mentioned on all of the stores where you buy them "WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before
operating" but no instructions anywhere...
that's a great explanation. thank!
Thanks for info on adding thread loc from the back to keep away from washers, those washers are tiny, an I lost one
Where'd you get the bearings for the bellcrank?
I bought them from Acer but many companies including Avid have them. There is a Hot Racing steering kit that comes with bearings but I'm not sure the size of those. Losi bearings are 3x6x2.5 that replace the 4 bushings.
@@jasonrobinson7343 thank you so much!!!
Great upgrade, but I am unhappy with the design because if you need to service this, you have to wait for loctite to cure before you can race at the track :( Need a way to nest a nylon locknut
I am in the middle of the same process and lost one of the washers, where can I get some new ones? Thanks for the video !!!!
I’d say these would work. www.amainhobbies.com/nexx-racing-2.54.20.35mm-shim-20-nx-189/p1289735
Is this same fit for mini t 2.0 mini t bearings ???
yes