How to Test Hoverboard Battery w/ Multimeter & Replace
ฝัง
- เผยแพร่เมื่อ 24 ก.ย. 2018
- Today we show you how to test a Hoverboard battery with a multimeter and if it's bad how to replace it.
Buy a Hoverboard replacement battery here: www.streetsaw.com/products/ho...
Send your old batteries to us for recycling:
3867 S Valley View Blvd #5
Las Veges, NV 89103
Websites:
www.streetsaw.com
hoverboardrepair.com
StreetSaw is an online retailer of self balancing electric scooters (more easily described as hoverboards) and has a store in Las Vegas, Nevada. The company now sells over 50 varieties of hoverboards, electric scooters, e-skateboards and more, and carries customized accessories as well. StreetSaw ships worldwide. Our sister site HoverboardRepair offers Hoverboard parts as well as performs mail-in hover board repairs nationwide. - กีฬา
I was overwhelmed at the prospect of troubleshooting a hoverboard that won't stop complaining about a low battery. Between this video and your website I think I can pull it off. I appreciate you making it easier
Thanks for sharing your knowledge
Thank you so much. I have looked for so long to find out the problem with my hover board and nothing helped at all. All other videos sucked and were unclear. I tested it with my multimeter and had the exact same readings as your faulty battery. Around 3.6. I’m about to buy a new one.
hamburger
You helped me a lot thanks
Thank you
Some battrries multimeter reading give 18-19 volts, its fine as this is the output of the internal controller board, if you opened the battry and probed the batteries directly, it will give you 36v
Where can we buy new batteries for hoverboard?
Bravo
How long do you need to charging the new battery after replacement or it gonna turn green after is fully charged
Any ideas why there is one(steady) consistent ringing?
Thanks!
like it!
Hi, I had a hoverboard in which batteries are dead when I tried to open the BMS board 2 MOSFET RU6888R A or short I can't find similar can I replace any N channel
MOSFET
Do we have to buy a charger to find out?
I revived My hover board battery and the voltage on B- and B+ show 38volts but through the actual xt60 connector it reads 25volts. I’m guessing it’s a faulty bms but it was working before this happened.
been a while and today I decided to ride my board but once I get on it goes off...the charger keepsblinking red/green ...what might the problem be??!batter or charger 🔌 ?please thanks
what are the other two wires for?
Hi! Just wondering what your location is. We have a swagtron that isn't working and want it to be repaired. Our swagtron won't turn on unless plugged in, and when it's plugged in it lights up red.
swagtron seems to be a very common problem - that's why I'm looking - check out how many diff youtube vids show problems with them! especially the red ones!
Hi. The charger battery briefly blinks red but then stays green. When I measure the voltage I get 32v though - not nearly as low as your battery here. Is that considered bad? The hoverboard doesn’t turn at all btw.
Mine too!! Did you figure this out? Maybe a bad charger?
@@alexismchone9477 did you figure this out?
Me too, my battery has 33v and connected to another motor works but only for a bit until it reaches 30v. I think it’s faulty but it’s not as bad
But mine did turn on
My battery is 12.8 v is it still good or it is dead?
where da ya get the battery from
Go to desc
whats the small circuit board next to the speaker? mine is burnt for some reason and doesnt look like the one on yours.
Sound board.
Where do you buy batteries
Tengo como 200 baterias de esas, donde puedo mandártelas..??
Brother can i buy a battery pack from you?
36volts
Im from the phillippines
3.8V is a FLAT battery - perhaps used to 'simulate' a dead battery - even a duff battery, off load, would produce over 20V
I have a 37vdc battery and it shows 01.8 when testing the battery with a multimeter. Problem is I can’t find a 37vdc battery for sale anywhere only 36 volt battery. Will a 36 volt battery be ok?
It doesn't matter if it is 36 or 37 volt battery. You can use a 36 volt battery for hoverboard
My brand new hoverboard run time is around 25 minutes then it cut off power of board. At full charge it was around 41.5 V and after 25 minutes the battery voltage was only 37.8 V for cut off. Why is the voltage still so high and already there was a cut off the power?
At wat voltage should the board switch off? Any suggestions?
It should switch off at around 30 volts so the cutoff is too high
I tested my battery and it reads 40.5V but is a 36v battery is this a bad battery
i have a problem with my hoverboard, it will randomly shut off while riding or when there is a large load (when you lean forwards too fast) but now its mostly just doing it on its own even when i go slow, i checked the battery and its at 41v even though its supposed to be 36v? i measured it from the end of the plug not the batteries them self so i dont really know whats going on here. im worried it might be a logic board problem but i overviewed the board and the components seem fine (no burn marks or anything) HOWEVER i did get this board refurbished and i actually got a refund for it so i basically got it for free so im not afraid to experiment with it but i would love to get it working again. batteries are around $40-50 new for a samsung brand battery so if i know for sure thats the problem i will go with name brand but i need someones help because im clueless, i tried testing the battery whilst it was plugged in to the board and im not sure if its my volti-meter or what but its not getting anything whatsoever, i tried switching to amps and testing it and somehow my meter shorted the connections through its self (fairly certain i didnt touch two pads by accident). edit: still powers on and functions. I was quick to remove the prong before it welded to the board or something.
Mine indicates BLUE on the board as if it's charging but it's been charging forever and it doesn't turn on !! Help
Hi, what voltage is it when it is empty? Mine reads 39.68 voltage when it is full even though it's a 36 volt battery. Also is it bad to run it to empty?
36 is average voltage. Most lithium ion batteries have voltage from 3 to 4.2 volts. So there are 10 cells in series and 2 in parallel. 4.2 x 10 = 42 volts and 3 x 10 = 30 volts. 39 is ok
where did you buy the batterie ?
Ebay
Try aliexpres but u will have to wait 3weeks
It says 35 volts on a 36 volt battery is the battery bad? Please react back
No, should be fine. Just make sure you charge it.
@@mojoo215🤣
Battery tested 25.2v battery testing at 24.4v hoverboard atill wont charge
what he doesnt tell you in this video that You can repair the battery! but he rather have you send it to him so he can enjoy all them cells
Fucking BINGO!!!!
Hi when I test my battery it shows 32.2v but when connected to the charger it shows 41.8v dose this mean my battery in knackerd cheers
It has been on charge for hours but stays at 32.2v
Thanks
you do't charge it while you read the volts, it basically puts more power into the battery unless theres is something really wrong with you're hoverboard
Sounds dangerous. Don’t test it while it’s plugged in!
Just bought a BRAND NEW ONE and it doesn't work at all. Do they have a customer service number where you can speak to humans??
Selling these batteries for a $100 when you can buy a brand new hoverboard for around that price. Nice try streetsaw
This is so fucking confusing. You say if the light is green and if when you plug it into the hoverboard if it stays green then is an indicator that is bad? WTF?
He's saying if your hoverboard was working and charging fine, you wouldn't look at this video.
Normally green means fully charged, but in this video it could mean battery not detected.
If you see red it indicates the battery is not full and is charging
HOLY $ _ _ _ !
YOU should DELETE...
This ? Video ?
This is NON-SENSE !
Yea I agree….he didn’t account for discharge or any other circuitry that goes between the AC charger and the battery…..wiring could be at fault or the circuitry in between like the bms