How to fit and remove a Caterham full hood

แชร์
ฝัง

ความคิดเห็น • 19

  • @henryrichardson2479
    @henryrichardson2479 ปีที่แล้ว +4

    Useful video.
    I’ve done 185 kph on an autobahn with the hood up with no issues. I did use the Velcro inside though as a precaution.
    Only difference I do is loosen the hood sticks when stowing the hood so when I’m at the side of the road in the pouring rain it’s one less thing to think about when putting the roof on!

  • @ColinCarFan
    @ColinCarFan ปีที่แล้ว +3

    As a Caterham newbie (I'm still building mine) I found this very interesting and useful. Thanks

  • @PatrickDarracq
    @PatrickDarracq 8 หลายเดือนก่อน +1

    Hi Callum !
    Thanks again for your comments.
    It is very usefull for me as i will get ma 170S end of 2024 , december gift 😉 , ... waiting for this long period... so , i am collecting all the data i can 👌😇

  • @TheLongboarder77
    @TheLongboarder77 10 วันที่ผ่านมา

    Central locking. lol. Love it

  • @rafaelgastelu1218
    @rafaelgastelu1218 หลายเดือนก่อน +1

    Excelente 👏👏👏

  • @markcoomber8222
    @markcoomber8222 8 หลายเดือนก่อน

    Excellently helpful video (for a Caterham newbie). Although I’m hoping not to need to use the full hood (!)

  • @ianscott3180
    @ianscott3180 5 หลายเดือนก่อน +1

    The trick is to sit in the drivers seat and ask someone else to put the hood up. I have a tonneau cover on my old 1700 crossflow. It is easy to put on and I can leave it half on when I am alone. It is lovely and warm with the heater on in winter. Note, this is not good solution if you have leather seats. I have an older car with bench seats which I can pull out and take indoors if they get wet. Less is more.

  • @PatrickDarracq
    @PatrickDarracq 8 หลายเดือนก่อน +1

    Hi Callum ! Thank you very much for your video 👍
    Could please explain how to close the door when you are inside the car with the total roof ?
    I mean properly, as you did from outside . Thanks very much.

    • @turn7caterham
      @turn7caterham  8 หลายเดือนก่อน +1

      Stick your fingers outside, from the front, and run them backwards pulling the door into the “slot channel”. It’s more intuitive than that sounds 😂

    • @PatrickDarracq
      @PatrickDarracq 8 หลายเดือนก่อน +1

      @@turn7caterham thank very much 👍😇

  • @helluvaname77
    @helluvaname77 ปีที่แล้ว +2

    Hi Callum 👋 Surely all you need is to show how to take the Full Hood off the car, and then just get a Soft Bits For Sevens Half Hood 😉. All the best 😊 (Ian B - Kent 7s)

  • @ronsummers4090
    @ronsummers4090 ปีที่แล้ว +1

    I have a question about closing and sealing the doors from the inside. How do you get the flap to sit in the right place?

    • @turn7caterham
      @turn7caterham  ปีที่แล้ว +1

      A ha! A fine question Ron. Hook it in with your fingers at the front, then you can pull your fingers back whilst hooked over the top of the door edge. Don't forget to stop when you get to the V-cut 😄 Have a practice, and if you're still struggling with it, comment back here and we'll make a Short to demonstrate 📹

    • @ronsummers4090
      @ronsummers4090 ปีที่แล้ว

      @@turn7caterham I pick up my 420r sometime in the next two months, I’ll let you know

  • @pablouvedoble
    @pablouvedoble 2 หลายเดือนก่อน

    What are the differences when using a trackday cage?

    • @turn7caterham
      @turn7caterham  2 หลายเดือนก่อน

      Getting in and out is a bit more awkward 😂 Hoods still fit over them though

    • @pablouvedoble
      @pablouvedoble 2 หลายเดือนก่อน +1

      @@turn7caterham Even more?? LMAO
      Thanks!!

  • @richardowen-hughes7868
    @richardowen-hughes7868 ปีที่แล้ว

    What witchcraft is this? Making it look easy! That's quite a trick... Another top guide, Callum.

  • @MrKayfano1972
    @MrKayfano1972 ปีที่แล้ว

    Мне кажется без дуги сзади салона, этот автомобиль смотрелся бы на много лучше, как первые лотосы 7