As a beach cat sailor we would first take the mainsheet system off the sail to prevent a new capsizing just after the boat comes up and to release the water on top of the main more quickly. Also a help-line attached to the mast makes it safer to lean backwards in order to push the lee-float under without the need to climb onto the slippery centreboard. This is particularly important for your own safety in big waves and you,ve got a rope to hold onto just in case you maybe slammed off by the motions of the boat. So that line we attach to the foot of the mast and take the other end to either side of the boat where we need it. Also when you sail with two people on board they need something to hold onto and not loose contact with the boat.
I've righted my Weta alone in 35 knots of wind with 3ft chop during a race. Uncleat the sheets before you start righting it then sink the windward hull and move fast into the cockpit as it comes up quickly once the wind gets under the sail.
I managed to turn mine over last weekend, wind had risen to 20 - 25 knots with 2 - 3 foot chop. I had been sailing for 6 1/2 hours at this point and was getting a bit tired. Righting the boat with my 90kg only took a few minutes, a lot easier than I had imagined it would be.
In Miranda's capsize recovery video it shows her furling the gennaker and uncleating the jib sheets before righting the boat. Forget that when racing - just get on with flooding the leeward ama by sitting on the front of the ama and bouncing on it to burp the air out - especially the last air bubble when it's under water but still not fully sunk, by standing on the front. Then when you're standing or kneeling on the daggerboard, just before you allow the mast tip out of the water - lean in to the cockpit to furl the gennaker and uncleat anything that needs it. Then right the boat and immediately grab the tiller to make sure you don't tack to avoid capsizing on the flooded hull which needs to be on the windward side as you sail upwind to drain it. Takes about 3 minutes
I did some right tests at 0 Wind with a Hobie 16. I can do it alone. No mast float. I use a pulley system and a watertight bag that i put on my back to get more weight. About 20kg of water + my 80 kg.
Over 1200 Wetas have been sold worldwide! Firstly it's really hard to capsize unless you fail to release something (as you can see in the outtakes). Secondly Miranda is light and you can flood the float much faster than shown if you sit and bounce right on the end or are a little heavier. For speed, I leave the sails alone until the boat if righted 90 degrees and then you can just uncleat the jib and furl the gennaker while standing on the daggerboard. There's generally no need to uncleat the main since the windward hull is flooded so it's not going to go over again and you need to sail upwind to get the water out of the float. There is a breather hole through the arms that attach the float to the boat - but its not large enough to flood the hull as it's designed to allow for air expansion/contraction in hot/cold conditions.
As a beach cat sailor we would first take the mainsheet system off the sail to prevent a new capsizing just after the boat comes up and to release the water on top of the main more quickly. Also a help-line attached to the mast makes it safer to lean backwards in order to push the lee-float under without the need to climb onto the slippery centreboard. This is particularly important for your own safety in big waves and you,ve got a rope to hold onto just in case you maybe slammed off by the motions of the boat. So that line we attach to the foot of the mast and take the other end to either side of the boat where we need it. Also when you sail with two people on board they need something to hold onto and not loose contact with the boat.
at last someone explaining how its done propley i think if i was to buy a boat this would be it and a kiwi design just great cheers
Excellent "toe control" at 5:12.
Incredible!!!
you need a tiny manual air valve at front of float to let air out.
Has anyone tried creating a righting line? We used to have one on our Hobie 16 and it was invaluable, especially when trying to right it solo.
You don't need one in a Weta - since the flooded hull allows it to right like a monohull. Then just sail away to drain the water out.
What if you are tired and alone and there are 3 ft waves ?
I've righted my Weta alone in 35 knots of wind with 3ft chop during a race. Uncleat the sheets before you start righting it then sink the windward hull and move fast into the cockpit as it comes up quickly once the wind gets under the sail.
I managed to turn mine over last weekend, wind had risen to 20 - 25 knots with 2 - 3 foot chop. I had been sailing for 6 1/2 hours at this point and was getting a bit tired. Righting the boat with my 90kg only took a few minutes, a lot easier than I had imagined it would be.
Why not uncleat mainsheet?
Would not try to do that in Lake Superior, USA, where the water is always about 60 degrees!
not fast when racing you would be last by the time you got it up but was very usefull
In Miranda's capsize recovery video it shows her furling the gennaker and uncleating the jib sheets before righting the boat.
Forget that when racing - just get on with flooding the leeward ama by sitting on the front of the ama and bouncing on it to burp the air out - especially the last air bubble when it's under water but still not fully sunk, by standing on the front.
Then when you're standing or kneeling on the daggerboard, just before you allow the mast tip out of the water - lean in to the cockpit to furl the gennaker and uncleat anything that needs it. Then right the boat and immediately grab the tiller to make sure you don't tack to avoid capsizing on the flooded hull which needs to be on the windward side as you sail upwind to drain it.
Takes about 3 minutes
What speed indicator are you using there?
I think it may have been a Velocitek SpeedPuck
@@WetaTrimarans Thanks!
You can not right a hobie 16 in no wind alone. Hard at least.
Mast float on this one also?
I did some right tests at 0 Wind with a Hobie 16. I can do it alone. No mast float. I use a pulley system and a watertight bag that i put on my back to get more weight. About 20kg of water + my 80 kg.
The Weta is not designed to have a mast float.
People buy this boat? It needs at least a few more details in its design such as a second air hole at least i think.
Over 1200 Wetas have been sold worldwide!
Firstly it's really hard to capsize unless you fail to release something (as you can see in the outtakes).
Secondly Miranda is light and you can flood the float much faster than shown if you sit and bounce right on the end or are a little heavier.
For speed, I leave the sails alone until the boat if righted 90 degrees and then you can just uncleat the jib and furl the gennaker while standing on the daggerboard. There's generally no need to uncleat the main since the windward hull is flooded so it's not going to go over again and you need to sail upwind to get the water out of the float.
There is a breather hole through the arms that attach the float to the boat - but its not large enough to flood the hull as it's designed to allow for air expansion/contraction in hot/cold conditions.