ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
Where is the video on fixing a bend in the front flange that you mentioned at the end of this video. I don't see it on your channel.
@@kencecil697 for the cutting edge it’s the same process I used for the top edge. I think I did another video on the sides. Let me check for it.
@@kencecil697 th-cam.com/video/PO-ImfYhiPI/w-d-xo.htmlsi=bEvRjEJ3wHxvK1DO
Can you use heat to ease the bend?
My bucket's 3/4" cutting edge is badly bent. I doubt if even my 6" vise will straighten it.Any ideas?
If you can email a pic to me I can give advice on easiest way. If it’s a bolt on edge most likely easiest way is to pull it and bend back with sledge.
I couldn't watch but five minutes, you talk to much.
Wow, you talk way too much. Just get to it
Seriously. Stupid shit
Where is the video on fixing a bend in the front flange that you mentioned at the end of this video. I don't see it on your channel.
@@kencecil697 for the cutting edge it’s the same process I used for the top edge. I think I did another video on the sides. Let me check for it.
@@kencecil697 th-cam.com/video/PO-ImfYhiPI/w-d-xo.htmlsi=bEvRjEJ3wHxvK1DO
Can you use heat to ease the bend?
My bucket's 3/4" cutting edge is badly bent. I doubt if even my 6" vise will straighten it.
Any ideas?
If you can email a pic to me I can give advice on easiest way. If it’s a bolt on edge most likely easiest way is to pull it and bend back with sledge.
I couldn't watch but five minutes, you talk to much.
Wow, you talk way too much. Just get to it
Seriously. Stupid shit