Stop Blowing Diffs On Your Outcast Or Kraton 8s!

IF YOUR BLOWING OUT YOUR DIFFS ON KRATON OR OUTCAST YOU HAVE TO CHECK SCREWS AND OR SWITCH TO ALUMINUM DIFF CASE.

[@JPTulo]

Regular loctite eats plastic. So if you try to Loctite screws into plastic, you’re going to have worse results than if you didn’t use loctite at all.

[@Seenb007]

I had all three come loose waiting on the center caps now and just checked the rear I just rebuilt and it came apart again as well need those aluminum caps asap 😢😢😢

[@northeastrc73]

Even with aluminum I’m having same trouble, going to epoxy the screws in so they don’t back out

[@Seenb007]

@northeastrc73 I was thinking that too but would have to just have to buy a bunch of diffs 😄

[@northeastrc73]

uploading new video now, pulled rear diff and it was fine so either the gears inside are going or it's in center diff
@@Seenb007

[@markcole6475]

@@northeastrc73why not just lock tight the screws into aluminum?

[@northeastrc73]

@@markcole6475 was the center diff, it’s fine now

[@scottrobillard6905]

I would of just made it a locked diff I did that with the centre and rear diff and then you only have to worry the outside ring gear

[@northeastrc73]

Yeah no I’m all good now so far

[@kaiarneberg9203]

Not axles and pins?

[@jasonluther7481]

This was a total waste of time.