Mrev2 Lower Plenum & Kinetix Upper Intake Modifications!!
ฝัง
- เผยแพร่เมื่อ 2 ต.ค. 2024
- In this video, I decided to do my own modifications to the two intake parts to help airflow. from the manufacturer, the top intake has a bad edge on the inside that I smoothed out to keep it from interfering with the flow. On the lower Mrev2 plenum I ride the small lips on top of the runners to help with the flow.
Enjoy the video hope it helps. - ยานยนต์และพาหนะ
this is some good hot rodding content!
Could use measure the distance from the top of the two front intake runners to the bottom of the flat inner surface? Could you tell me what those measurements are?
I just tried to replicate Motordyne’ amid by shaving down the runners myself; but I’m not sure I shave it down far enough.
Unfortunately I can't I have the plenum installed and I have gasket maker between that and the kinetix intake so I kinda a paint to take off. Are you using a DE plenum?
@@latenightgarage7895 Yes, I’m using a “long-runner” DE plenum; I just measured the thickness on my two front runners - they are both ~9.5mm after I shaved them.
@@755hp nice I was wondering if the DE was basically the same
@@latenightgarage7895 Let me clarify - I have a 2006 RevUp engine; but I’m installing/modifying a non-RevUp lower plenum.
@@755hp yeah I should have put a Non Rev Up DE plenum 03 to 05 but I gotcha 👌, I hope your modifications help improve the air flow for more power!