Good man using thread lock, but you know what you should do so you don't sheer the packing, screw the piston valve on but don't tighten yet, get the rod and packings in the sleeve then tighten the piston valve so it bulges in the sleeve.
Is that the same for 3400? I have problem with pressure is not stable and lines from 4 inch gets down to 3 inch and go back the 4 inch all the time and mechanic couldn't find the problem. Any ideas???
You might be getting pulsing because there is something preventing the ball from seating on the valve properly or you're using a shorter than 50ft hose, if it builds pressure and holds for 40secs+ it could be a short hose, if you have a short hose, just something to keep in mind tho.
The most helpful video I found thanks for sharing
Thank you for sharing this video 👍
Good man using thread lock, but you know what you should do so you don't sheer the packing, screw the piston valve on but don't tighten yet, get the rod and packings in the sleeve then tighten the piston valve so it bulges in the sleeve.
This is awesome thank you so very much.
Thanks a lot . Could be nice repack the 200 hs
How do i replace honda engine on a 3900 line lazer 4
Is that the same for 3400?
I have problem with pressure is not stable and lines from 4 inch gets down to 3 inch and go back the 4 inch all the time and mechanic couldn't find the problem.
Any ideas???
Try a new Tip?
Thank you for this!
💦반갑습니다,수고하십니다,항상건겅하시고 복받으시길바랍니다,,,Elastic coating (탄성코트)work on veranda wall..............
Anyone have a video on how to replace the pump on a V 5900 line laser?
Replace the pump? If it's just a repack you can use this same video, pump is a little smaller in video but same set up.
How about NOT SKIPPING THE PART THAT WOULD SHOW HOW TO REMOVE THE PUMP!!!!
What was the reason you had to repack that was it pulsing or something else??
Bad packings.
You might be getting pulsing because there is something preventing the ball from seating on the valve properly or you're using a shorter than 50ft hose, if it builds pressure and holds for 40secs+ it could be a short hose, if you have a short hose, just something to keep in mind tho.
We call it hourglassing, in our case it’s usually caused by the filter being clogged or the wrong mesh.