New Fuel pressure sensor Ebay - ebay.us/tve1Jt Tools : Multi meter - ebay.us/fvsMub Socket set - amzn.to/3eGx2Ak Ring Inspection Lamp - amzn.to/3gGWHcG Needle nose pliers - ebay.us/272Psu Check out my other Vauxhall / Renault videos : Vauxhall : th-cam.com/play/PLDTPJANi9HjqQOjkgvfEDuF2tbgOpgZuc.html Renault : th-cam.com/play/PLDTPJANi9HjrkE0q8cjDi87PhuVtz2l-i.html
Nice. Had a no start problem, watched this video, identified my pressure sensor and... The connector was totally loose! It's not locking into place, but as soon as I pushed it in, I got life. Was seriously considering having it towed but it turned out to be that simple.
i know this is an old video but my signal wire is saying 4.99v and 5v on pin 1. its a new sensor and plug. continuity on all 3 wires all check out. im stumped
I had a VW Golf 1.4 tsi twin charge with snapped fuel pressure sensor. I bought a second hand one, did not work. so I bought a new one off ebay for thirty pounds ,that did not work. Then I bought a genuine bosch unit, and there you go, works. lesson learned, don't be a tight arse and buy the genuine part. it was only five pounds more. (the pound sign on my laptop is broken)
haha! I know the feeling 😖 been there before , also been sent down the wrong route after fitting second hand bits and not realising they were faulty.. Had an ABS unit sent to BBA reman once (they said it tested ok) spend another 2 days checking wiring etc.. was sure it was the pump.. fitted a new pump and Bingo! fault cured. Must admit I do always try get at least (middle of the road) brand parts now , doesn't take many issues for you to loose confidence in cheap parts does it 😂
Hi mate, What does it mean if the feed wire only reads 1.5v. The signal reading is fine just the 3rd pin. It's the same for the feed wire for a few sensors. The van battery is full. It was driving and died as I was driving off my drive.
Many thanks, I'll be checking mine in the morning. I am getting poor slow starting and surging throttle . No boost leaks found so I would be guessing but hopefully this might have saved me wasting my money at the worst
@@diydaly cheers for the reply. It definitely is harder to start on colder days and need to get it sorted before I kill my battery in winter. I may swap all the horrible plastic fuel pipe for some rubber as the quick fittings are rubbish too
@@diydaly I don't have a bulb on mine for some reason but if it is and air leak it on sucks in when the fuel pressure drops off after being switched off. Might be tomorrow before I get on it looking at this weather
I’m getting a po191-c Fuel Rail Pressure Sensor Circuit Range Performance fault. Brand new sensor. Followed your diagnostic procedure but I am getting 7.5v on the signal wire, you are getting 5v. Signal and ground wire test good. Any ideas on this ? Thanks 🙏
New Fuel pressure sensor Ebay - ebay.us/tve1Jt
Tools :
Multi meter - ebay.us/fvsMub
Socket set - amzn.to/3eGx2Ak
Ring Inspection Lamp - amzn.to/3gGWHcG
Needle nose pliers - ebay.us/272Psu
Check out my other Vauxhall / Renault videos :
Vauxhall : th-cam.com/play/PLDTPJANi9HjqQOjkgvfEDuF2tbgOpgZuc.html
Renault : th-cam.com/play/PLDTPJANi9HjrkE0q8cjDi87PhuVtz2l-i.html
Nice. Had a no start problem, watched this video, identified my pressure sensor and... The connector was totally loose! It's not locking into place, but as soon as I pushed it in, I got life. Was seriously considering having it towed but it turned out to be that simple.
Nice one! Thanks for the tip .. much appreciated 😀👍 glad it helped you 👍🙌
Thanks
Nice diagnosis. Thanks for taking the time to video.
Thanks trev 😄👍
Great clips very thorough and informative thank you
Very welcome, thanks 👍👍
Clearly and well explained thankyou
Glad to help 👍
i know this is an old video but my signal wire is saying 4.99v and 5v on pin 1. its a new sensor and plug. continuity on all 3 wires all check out. im stumped
Very helpful thanks.
👍👍
Nice video very well explained top job👍
Thanks Kev! 👍👍👌
I had a VW Golf 1.4 tsi twin charge with snapped fuel pressure sensor. I bought a second hand one, did not work. so I bought a new one off ebay for thirty pounds ,that did not work. Then I bought a genuine bosch unit, and there you go, works. lesson learned, don't be a tight arse and buy the genuine part. it was only five pounds more. (the pound sign on my laptop is broken)
haha! I know the feeling 😖 been there before , also been sent down the wrong route after fitting second hand bits and not realising they were faulty.. Had an ABS unit sent to BBA reman once (they said it tested ok) spend another 2 days checking wiring etc.. was sure it was the pump.. fitted a new pump and Bingo! fault cured. Must admit I do always try get at least (middle of the road) brand parts now , doesn't take many issues for you to loose confidence in cheap parts does it 😂
@@diydaly Had issues with bba here, sent me round the houses more than once, use another firm now, so far so good.
@@toeknee6588 yeah same mate, we've gone to ECU testing now 👍
@@diydaly snap!
Yea but can it be the blue rellay ? I mean the yellow cable from it ?
With the connector off, I got 5 volts on both pins, rather than 5 volts and 4.7 volts. Is that within tolerance ? Thanks.
Hi mate,
What does it mean if the feed wire only reads 1.5v.
The signal reading is fine just the 3rd pin.
It's the same for the feed wire for a few sensors.
The van battery is full. It was driving and died as I was driving off my drive.
Pull on the wires there is a good chance you have a broken wire just a bit back from the plug
Got same issue but no broken wire
Hi same problem changed sensor got the right voltage on feed and signal and got a ground. But still fault code up and won't start
Have you checked the primer pump to make sure it’s not split?
2.5 traffic 2005 won't stay running and stalls I have 9 different fault codes. Could this be ecu? Or circuit breakdown?
Many thanks, I'll be checking mine in the morning. I am getting poor slow starting and surging throttle . No boost leaks found so I would be guessing but hopefully this might have saved me wasting my money at the worst
Thanks , hope it might help, be worth checking for any air leaks into the fuel system
@@diydaly cheers for the reply. It definitely is harder to start on colder days and need to get it sorted before I kill my battery in winter. I may swap all the horrible plastic fuel pipe for some rubber as the quick fittings are rubbish too
@@karlmyers6518 yeah there usually too bad tbf though mate, the most common area is the primer bulb
@@diydaly I don't have a bulb on mine for some reason but if it is and air leak it on sucks in when the fuel pressure drops off after being switched off. Might be tomorrow before I get on it looking at this weather
@@karlmyers6518 👍
I’m getting a po191-c Fuel Rail Pressure Sensor Circuit
Range Performance fault. Brand new sensor. Followed your diagnostic procedure but I am getting 7.5v on the signal wire, you are getting 5v. Signal and ground wire test good. Any ideas on this ? Thanks 🙏
I have Renault trafic 2001 non starter it has same switch, however fuel is getting up to and past injectors, can switch still be faulty?
yes could still be the switch
What is the Bosch Part Number for this sensor?
Thanks , I’ve attached a link to the same one, the Bosch number is on the link mate ebay.us/u6luqb
Diolch!
O i you show us how easy it is to find then you rip people off when you fix it plit ars mcannics
Hi
Replied to other message