Hello, I bought the matek g474 and installed it on the gaui x3, everything works very well however, when the aggressive collective moves a little How can I make a tighter adjustment to the syrup so that it stays locked? thanks
in the Servo section, what's the difference between changing the "Center" value, compare to changing "Trim" value ? either can be used to center the servo. for some reason, rotorflight gives warning if Min and Max values are not the same for given servo.
I believe they will both work in Rotorflight 1. I used "trim" in the video, and it worked fine. I have started using the "center" field to adjust the servo center. In Rotorflight 2, "center" is the correct way. The "trim" option is no longer in the servo tab. Since that is the way to do it in RF2, I also started doing it in RF1. Not sure why you get a warning with the min max. what does the warning say?
Hello dimitrybattesti7930, I don't understand your question. Are you asking about changing from Kbar to Rotorflight? There are many versions of the 450trex, which one are you working with?
I haven't played with angle or horizon mode. I would try the defaults. You could ask on the discord. I think there are people on there who have used them.
Hello, I bought the matek g474 and installed it on the gaui x3, everything works very well however, when the aggressive collective moves a little How can I make a tighter adjustment to the syrup so that it stays locked? thanks
in the Servo section, what's the difference between changing the "Center" value, compare to changing "Trim" value ?
either can be used to center the servo.
for some reason, rotorflight gives warning if Min and Max values are not the same for given servo.
I believe they will both work in Rotorflight 1. I used "trim" in the video, and it worked fine. I have started using the "center" field to adjust the servo center. In Rotorflight 2, "center" is the correct way. The "trim" option is no longer in the servo tab. Since that is the way to do it in RF2, I also started doing it in RF1.
Not sure why you get a warning with the min max. what does the warning say?
@@4CFPV I upgraded to rotorflight 2 after reading your message, and that min max value not equal warning is no longer appearing.
Bonjour est ce que je peut régler mon 450trex avec non gyroscope kbar stp merci
Hello dimitrybattesti7930, I don't understand your question. Are you asking about changing from Kbar to Rotorflight? There are many versions of the 450trex, which one are you working with?
Hi,
Can I uae this application in any FBL used in micro type helicopter??
Do you have some recommendation on the values for Angle mode and Horizon mode ?
I'm trying to achieve stable flight, not anything 3D.
I haven't played with angle or horizon mode. I would try the defaults. You could ask on the discord. I think there are people on there who have used them.
In stabilized mode it does not turn?
It should turn. Yaw should work same as it usually does. Roll and pitch should be limited to a set angle.
Is the configuration on the radio helicopter or does it leave it as an airplane? Good morning
I didn't use any mixes from the heli tab. Flight controllers like simple configurations with no mixes, trims or sub trims.
The maximum frequency of the PID loop is limited by the power of
Portuguese
CPU processing. CPU load should not exceed 70%
with selected loop speed