got a 2.5t mondeo mk4 with car jerks continously...even sometimes the car stop running....my DTC are 00, but I see a lot of codes in ports and imputs....those mean someting?
Other than resetting trip mileage, no. Some software versions have option to adjust average fuel economy calculation by few percent, so you can change that but still no damage to the car.
Can someone tell me where is the aerial signal/frequency. I don't want to get radiated, getting brain tumor due to this radio antenna. I can see that it doesn't exist as it once was on the previous models such as, Mondeo Mk3. But, where is located the magnetic radio wave? Most of cars, almost all of them, have the antenna and aerial signal at the end of them, near the trunk. Mondeo or Focus until recently considered that is "very good" for the customers to have antenna just above the front passengers. Where is the antenna signal when it comes to MK4 (facelift) and MK5? Thank you!
If you're talking about radio antenna, then AFAIK it doesn't matter where it's located in your car because it's just a passive receiver. It does not transmits and does not radiates anything.
most likely this means that your car rolled a bit after turning the ignition on. this is a live counter of the ABS sensor which is used to count your milage.
Output test is a diagnostic procedure. For example if you have fuel gauge that is not showing correct value, you can start with the needle test to see if the gauge is working in it's range. You can also check raw data send from the fuel level sensor to see if it's correct. Same goes for the RPM, speedometer, coolant temp. Sometimes you want digital readout of the coolant/oil temp to monitor it during DPF regeneration. There are all kinds of reasons why this menu is useful.
so I have a crown Victoria and I got the hidden menu to come up. but I was just driving and it came on. my gages and everything have been going on and off lately and this time when they turned on I noticed the menu. any feed back any one?
+Michaelnova Novak21156 if the hidden menu is entering itself, check if your trip reset button is not stuck in pressed position. if it's just the needle sweep, most likely you have a bad power connection in your instrument cluster.
Details over here: mr-fix.info/hidden-menu-ford-mondeo-mk4-s-max/
Hi a used this to reset my clock now the whole thing is blank any sugestions how to get it working again
Do you count it as the Fourth Generation or Third I count it as the Thrid we had a Second Generation Mk3.
got a 2.5t mondeo mk4 with car jerks continously...even sometimes the car stop running....my DTC are 00, but I see a lot of codes in ports and imputs....those mean someting?
what does the car in the green triangle mean?
How to do this on the keyless start ?
Press START without touching pedals.
how to open a car or bonnet without a car battery? The metal key opens the door without a battery?
Bonnet mechanism is mechanical and does not require electrical power. It should open with key.
Does this also show any fault codes? Or is that only visible with the OBD2?
The fault codes were shown on the list as none, it's (DTC)
Hello Mr.Fix , do you know if that can couse any sort of damage or data loss ?
Thanks
Other than resetting trip mileage, no.
Some software versions have option to adjust average fuel economy calculation by few percent, so you can change that but still no damage to the car.
Can someone tell me where is the aerial signal/frequency. I don't want to get radiated, getting brain tumor due to this radio antenna. I can see that it doesn't exist as it once was on the previous models such as, Mondeo Mk3. But, where is located the magnetic radio wave?
Most of cars, almost all of them, have the antenna and aerial signal at the end of them, near the trunk. Mondeo or Focus until recently considered that is "very good" for the customers to have antenna just above the front passengers. Where is the antenna signal when it comes to MK4 (facelift) and MK5? Thank you!
If you're talking about radio antenna, then AFAIK it doesn't matter where it's located in your car because it's just a passive receiver. It does not transmits and does not radiates anything.
mr-fix Even if I have the antenna just above my head as it is located on MK3 Mondeo 2005 model? It's not dangerous?
It's safe because it is not transmitting anything.
mr-fix Thank you for your time and answer!
Hello, what mean "ODO roll count 1", on other video on YT I saw "ODO roll cout 0", it is connetced with odo fraud??
Regards
Most likely it's raw signal from ABS sensor for the odometer.
But it can point that odometer was fraud?
no.
+mr-fix So can you explain what that's mean please?
most likely this means that your car rolled a bit after turning the ignition on. this is a live counter of the ABS sensor which is used to count your milage.
How does it work for versions with on/off button? Thx
Just press the button instead of turning the key. Even if engine starts - test mode will be active.
Wish you could have this on the dash all the time
MR fix
What is the point of doing this?
Output test is a diagnostic procedure. For example if you have fuel gauge that is not showing correct value, you can start with the needle test to see if the gauge is working in it's range. You can also check raw data send from the fuel level sensor to see if it's correct.
Same goes for the RPM, speedometer, coolant temp.
Sometimes you want digital readout of the coolant/oil temp to monitor it during DPF regeneration.
There are all kinds of reasons why this menu is useful.
so I have a crown Victoria and I got the hidden menu to come up. but I was just driving and it came on. my gages and everything have been going on and off lately and this time when they turned on I noticed the menu. any feed back any one?
+Michaelnova Novak21156 if the hidden menu is entering itself, check if your trip reset button is not stuck in pressed position.
if it's just the needle sweep, most likely you have a bad power connection in your instrument cluster.
Interesting, but ugly design, one round speedo and one half circle rpm meter........