Ford Mondeo MK4 tachometer / speedometer change / MiniDOT to Convers+ / Forscan mileage adjustment
ฝัง
- เผยแพร่เมื่อ 5 ต.ค. 2024
- Change small dashboard MiniDOT to Convers+ on Ford Mondeo MK4 2.0 TDCI 2009. Mileage adjustment via Forscan.
Výměna rychloměru (budíků) MiniDOT za Converse+ na vozu Ford Mondeo MK4 2.0TDCI. Nastavení ujetých kilometrů pomocí Forscan.
Music:
Rocky Mountains - Scandinavianz [Audio Library Release] · Free Copyright-safe Music - ยานยนต์และพาหนะ
![โรงเรียนตอนตี 2 โคตรหลอน..!! [โรงเรียนไดเม่]](http://i.ytimg.com/vi/2MAEMwqVYh8/mqdefault.jpg)
Thanks a lot! I just needed to replace the front speaker of the PDC but didn't know how to remove the tachometer. After this video it was super easy! Thank you!👌
Hi. How to know exactly wich convers speedometer is right for car? Or any facelift diesel speedo from mondeo, smax, galaxy will work? I have mondeo 2011 1.6tdci estate.
If you have Mondeo MK4 facelift diesel, you have to use Mondeo MK4 facelift diesel dashboard - tacho. Does not matter if maxidot or convers. You just have to keep the car model, generation and fuel.
Hola amigo muy buen trabajo!! El inmovilizador está el IPC? También tuviste que sincronizar las llaves?
Hello, no key adjustment is needed. Just exchange of dashboard and mileage adjustment. Nothing else is needed.
Hello friend! is it possible to use 2014 ford mondeo steering wheel and speedometer in 2010 ford focus? I have a 2010 Ford Focus and I would like to use the steering wheel and this digital speedometer, but I need to know if it is possible to exchange the information so as not to have a reading error. can you give me this information?
Hello, unfortunately I have no experiences with Focus. Only Mondeo and S-max.
i got the same as the one you replaced, but i got a problem (especially during winter) that none of the electronics works. The engine starts fine, but sometimes when i start my car or while i drive, the electronics shuts off. So i cant see how fast i drive, how much fuel is left etc. Even the mid consoler doesnt have electricity. Checked all the fuses, and nothing was wrong with it.
This doesnt happen often, but enough to be annoying. A friend of mine checked it, and he just used his fist and knocked on the dashboard, right behind the steeringwheel, and all the electronics worked again.
Do you think its just a wire that got a loose connection? such as the connection wire you disconnected?
Hi, try just to remove the connector, spray with electric cleaner at the pins in the instrument part of connector and install everything again as in video. Most probably bad connection. A common problem.
Hi, this is hard to say what could be wrong. As a first thing I would try to check cables going to the connector if there are not loose. Then I would tr to spray and clean the connector and as a last thing I would try to change the dashboard back to original if the problem is still there. If yes the problem will be in the connectors or cables, if not the problem is with the dashboard.
Hmmm, jste sikovny!
Děkuji! Mé služby jsou Vám kdykoliv k dispozici! 😆
Great video friend, tnx 🙏.
Do you now is it posible to register / activate climate controler for Mondeo with this Forscan? Just did the face lift to my from 2010 tdci 2,0 Ecconetic. The only problem is climatecontroler. Thank you 🙏
Hi, thank you. With the forcan you can set entertainment level of the car which includes also changes in climacontroler. But I never tested it personally so I cannot tell you for sure.
Thanks for the very good tutorial! What kind of diagnostic tool are you using for Ford?
Hi, thank you. I am using vLinker FD+.
Hey - awesome video :) thanks. Quick question - I have 2007 Pb with km/h - do I need to find Convers for this exact one? I mean mostly kmh and year of production. Or all I should be worried is type of fuel? I' veen british clocks have also kmh numbers so I can change clocks later on I guess but I am afraid if I should seek for very specyfic for 2007 or any for MK4 will do?
Hi, thank you. The gasoline version has more RPM than diesel one. So in my opinion you should use dashboard from the same type of fuel as you have. Mileage you can adjust upwards by yourself using OBD diagnostic and Forscan extended licence. Downwards you have to find somebody with special diagnostic. About the year - you just need to keep pre-facelift version. Facelift version could be used but it has to be adjusted by somebody who knows how to do it - otherwise the airbag sign icon will appear.
I have problems with interior light?
With old one it works. When i put the converse+ in everything works accept interior light.
Please help
Unfortunately I have no clue why you interior light doesn't work. I never faced to the similar problem.
hi very helpful vid is there any chance that i can do the mileage correction by myself?Just bought converse + and i’m about to swap it
You can adjust kilometers upwards using Forscan extended licence.
Zdravím, jaký kabel jste prosím použil? Mám Forscan extended a při posledním kroku přenastavení nájezdu mi Forscan vyhodí chybu "servisní procedura byla přerušena". Mám kabel ELM327 v1.5 s manuálním přepínačem HS/MS CAN. Na rozdíl od Vás potřebuji nájezd snížit. Díky za odpověď. Auto je Mondeo 2.0 TDCi 2011, budíky convers+ facelift.
Zdravím, já používám kabelovou verzi ELM 327 s manuálním přepínačem a pak BT verzi vLinker FD s automatickým přepínáním. Nicméně pokud se nemýlím, tak přes Forscan lze upravit kilometry pouze směrem nahoru. Na snížení bude pravděpodobně potřeba jiný SW. Který bohužel nevím.
Hello
i have a mondeo mk4 and i have changed the instrument cluster but as soon as i connect it a beeping noise starts
I would recommend to connect car to the diag to see what is happening.
I installed a Mondeo on a Galaxy but it keep beeping. Like an open door beep. Any idea what it can be? Both are none titanium models. My Galaxy had the small middle lcd blacked out
Hi, I would recommend to read error codes on diagnostic. Normally when you change dashboard no beeping is present.
hi m8, I have changed mine but I have the buzzer continuously on and I dtc regarding wrong configuration, do you have any ideea why?
Hi, actually I don't have any issue with buzzer after swap. Try to figure out which configuration is not correct. In my case I only changed the mileage on the dashboard nothing more. A did this swap o my both cars - mondeo and s-max.
Will this work on a Ford S-Max 1.8 TDCI from October 2006?
Yes it will work. Only problem could be with old radio unit that will not show on the dashboard what is playing. Same as on my video.
@@Placekmich I have an Chinese Android radio.
I saw in some video comment that it doesn't work on 2006 S-Max, it will not light up the dash lights.
My s-max is from end of 2006 and it works. If you have Android radio and correct canbus it should work normally...
@@Placekmich There's a more beautiful dashboard from FORDS-MAX (WA6)1.6 TDCi
[2011-2014].
Do you know if it is also compatible with October 2006 1.8TDCI Ford S-Max?
Or have to be like the one you show in your video?
@@PModesto It could be used but there has to be modified firmware in the dashboard unit. Without this update it is not compatible.
Hi.
I need to put new clocks in my mondeo mk4 as clusters gone, will I be able download and use forscan for free?
Hi, yes. Forscan can be download from page forscan.org and there is also possibility to get 2 moths extended licence for free.
Hello friends! I have a question, my car is left-hand drive, can I install a dashboard from a right-hand drive car? Will the buzzer work with lights left on when opening the front left door? Thanks!
Hi, honestly I don't know... But I think it should work, because all open doors are visible on the dashboard...
@@Placekmich Very hard to find a left hand drive dash. I'm looking for a right-hand mounting panel. Thanks for the help! I'm glad there are people like you. Greetings!
In my opinion, it would be necessary to use alarm clocks with miles.
Super videa mám dotaz. Jak jsi dostal češtinu + stejný nájezd mám GALAXY 2010 2,2 tdci. Mám stejnou diagnostiku jen základní.
Díky! Nájezd jde změnit směrem nahoru s rozšířenou licenci forscan (na 2 měsíce zdarma a dá se obnovovat po vypršení) - to byl můj případ, budíky měly min než moje auto. Češtinu jsem nechal nahrát od kluka z Ford fóra. Nahrál mi češtinu na parkovišti před lidlem za 10 min ☺️
@@Placekmich Díky moc. Jinak videa pěkně a srozumitelně natočená nevzdávej se já teď čistil u svého 2.2 129 kW EGR na prášky. Toč dál držím palce.
hi, can i put this dashboard in a pre fl model 2007?
Hi, yes. This dashboard is pre-facelift version.
Hello, is it possible to go back on km? I want to change my gauges too but actually my maxydot has 190k and the convers+ has 249k, need to go back on km. Can do it with the same program? Thanks
Hi, unfortunately it is not possible via Forscan. With this software you can increase KM only. Maybe with using UCDS software it will be possible, but this I did not test.
@@Placekmich thanks, I'll check it 😜
Ahoj chcem sa spýtať či sa dá kúpiť novy budík alebo len používane sa dá zohnať.Poprípade kde by sa dalo zohnať ? Ďakujem Vopred.
Ahoj, o novým jsem neuvažoval a ani nehledal, podle mě to bude strašně drahé a možná i nesehnatelne. Na druhou stranu používaných se dá sehnat relativně dost a je spousta lidí, co je dokáží modifikovat na lepší funkce.
ja sem si teď koupil ten converse+ a jdu to vyměnit a už teď mám hrůzu z toho nastavení…hlavně km at pasujou atd atd
Ahoj, kúpil som si nové OBD, origo k aplikácii forscan a stále mi neukazuje položku nájazd kilometrov, potrebujem kilometre znížiť, poraď čo mám robiť aby mi to fungovalo
Ahoj, podle stránek forscan.org jdou kilometry pouze navýšit a to z rozšířenou licencí, která je zdarma na 2 měsíce (pak se dá znovu prodloužit). Pokud potřebuješ jít s KM dolů, budeš potřebovat pravděpodobně jiný SW. Bohužel já takový neznám. Ale na Ford fóru, nabízejí dohrání různých funkcí do budíků Convers+ tak by mohli umět i snížit km.
Akú verziu forscan si mal nainštalovanú keď si to resetoval
2.3.46
Ahoj, vymenil som si budíky presne také isté ako máš aj ty. Tiež použivam Forscan , ale kolonka zápis nájezdu mi tam nevyskakuje, tým pádom si nemôžem upraviť kilometre, aký máš upgrade Forscan
Ahoj, jde to přes forscan extended licenci která je free na dva měsíce (ale pak se dá znovu obnovit). Návod najdes na stránkách forscan.org
Mám kúpenú licenciu ale nechce mi načítať riadiacu jednotku budíkov, namontované ani origo rádio. Skúsim namontovať origo rádio aj s origo budíkmi , uvidím čo mi to ukáže.
Zistil som čím to asi bude, nemám origo obd pre Forscan, tým pádom mi neprenáša všetky údaje. Idem zohnať origo OBD potom dám vedieť.
Ahoj.Bude pasovat nova pristrojovka,taka aku si daval aj na mondeo 2007,2.0 benzin 107 kw?Dakujem
Ahoj, pokud se jedná o Mondeo MK 4, tak ano. Je musíš hledat benzinovou verzi (má víc otáček na otáčkoměru).
Dakujem velmi pekne za odpoved.Nooo dufam ze najdem.
Can this be done on. Grand x max 2011
Hi, I am not sure, but I think that it cannot be done at grand c max. It could be done on mondeo, s-max and Galaxy for sure.
Is this plug and play or does it need coding
Coding is needed just for mileage correction. The rest is just plug and play.
@@Placekmichplease help me somebody with the mileage correction i bought the cluster instrument and i’m actually angry…now i have to find the right person with right skills and right program for it
Do you know how to change from MPH in KPH?
Hi, probably via diagnostic, but honestly I never did this change.
Hi did you solved ?
Diagnostic interface and program mame please
Hi, I am using Forscan software (it's free) and modified Elm 327 scanner with ftdi chip a.aliexpress.com/_Ew6yCE9