I'm a big fan of both of your channels. I was curious if you were going to cap the ends of the tubes to keep out the water and salt from the winter. Keep up the great job and I look forward to the next vlog.
thanks for the video. I am swapping a Jeep CJ 7 with an LS 5.3 engine, 4l60 transmission and I have an issue with mounting the gearbox and transfer case. The space between the transfer outlet and the rear differential is too short, the pinion angles are too much. In addition to the double driveshaft I would like to modify the angle of the engine. how can I do it? How many degrees can I lower the engine? Is there a video where it is explained
looks great but ive gotta wonder if with a manual you wouldnt have alot of jerky stuff cause there isnt any hard rubber to help absorb the vibes? How did it turn out or have you got a chance to get on it any? GREAT JOB.Dang i need a good welder!!!
Nice fab job Jerry.
Awesome work mate, you did a great job, would love to do this swap in a Jeep one day
Nice job!
Should work out just fine for you . Good job Jerry ! Until next time take care .
Thank you for watching
I'm a big fan of both of your channels. I was curious if you were going to cap the ends of the tubes to keep out the water and salt from the winter. Keep up the great job and I look forward to the next vlog.
I’m keeping the ends open just for the reason that if they trap water inside it won’t freeze in the winter and expand/crack the tube
@@TestDontguess That's a good point. I didn't think of that.
thanks for the video. I am swapping a Jeep CJ 7 with an LS 5.3 engine, 4l60 transmission and I have an issue with mounting the gearbox and transfer case. The space between the transfer outlet and the rear differential is too short, the pinion angles are too much. In addition to the double driveshaft I would like to modify the angle of the engine. how can I do it? How many degrees can I lower the engine? Is there a video where it is explained
looks great but ive gotta wonder if with a manual you wouldnt have alot of jerky stuff cause there isnt any hard rubber to help absorb the vibes? How did it turn out or have you got a chance to get on it any? GREAT JOB.Dang i need a good welder!!!
Sweet man fricken awesome..
Are you planning on a skid of sorts?
Next you can make custom jeep tranny mounts ..I want one for my xj. Seriously it looks tougher than the dorman one I have
Nice job!
Nice job!