There isn't, but now that you say that maybe it would have been a good idea....from the factory there wasn't either but then again the factory setup disintegrated into small bits....
I drilled and tapped a M14 thread into it, then used a bolt to hold it in the chuck with a live center on the other side. Turned down the part which actually fits into the chuck, flipped it and trued it all up, then cut it in half and that's where the video starts
Have a good holiday... When you are back the wiring video would be good.
I'll make one soon!
Nice
I'm only just over a minute in and I want to know how you turned down that first bit - who cares about OSHA 😂
you got there in the end - is there an o-ring or something in there?
There isn't, but now that you say that maybe it would have been a good idea....from the factory there wasn't either but then again the factory setup disintegrated into small bits....
I drilled and tapped a M14 thread into it, then used a bolt to hold it in the chuck with a live center on the other side. Turned down the part which actually fits into the chuck, flipped it and trued it all up, then cut it in half and that's where the video starts
@@DmitriIvanov it was good to see a good honest struggle with the job. And remind me to ask you what kind of Canon _not_ to buy when the time comes. 🤣
It's a g7x mark 2, I heard the mark 3 is even worse. When your fingers get grimy the touchscreen doesn't like to work anymore....