Have you had any issues with this over heating? Our fan isn’t kicking on. Love the wiper and rearview! I’m going to look into those. The lights are great too!
@@emilyboone2778 The wiper works great but scratches the windshield.If you put one on yours I would put some easy to remove window tint on the outside side of the windshield that way if it gets scratched just peal it off and put on a new piece.I haven’t had any issues with over heating. Troubleshoot the fan by hooking power directly to it If it doesn’t come on then the fan is bad. Then troubleshoot the switch it should be on lower driver side of radiator.
Due for my first oil change and there is controversy on whether or not to use conventional or full synthetic oil. The manual doesn't specify which and someone mentioned to me that full synthetic oil can cause clutch slippage. Any recommendations?
@@jamesm568 I mostly use mine off-road at about 1/2 speed noise and heat haven’t been an issue for me so far. I’ve been busy wiring up all my accessories the last couple of weeks.
@@rtdave6982 I haven't added auxiliary lighting, but I did convert every light to LED and that made a world of a difference, especially with the LED headlights. Best thing I ever done was put a switch on the electric fan.
I added a voltmeter to mine with all the front lights on The voltage only drops to about 12.5 which is good. After I run it with the lights on I always let it run some with the lights off for a few minutes before parking it. Do you have a multi meter?
Hard to say what you can add without knowing how much your light amp draw is. If you have a inline fuse for your lights which you should you can put a 10 amp fuse in the holder and see if turning the lights on blows the fuse if it doesn’t blow then your under 10 amps and good to go.
I like mine I would recommend buying it just plug in your seat belts to avoid RPM limiting to 4000RPM I found mine at Tractor Supply on a sale discount
![เจ็บที่ยังฮัก - ม่อน วรวิทย์ [ Official Mv ] จอนนี่มิวสิค](http://i.ytimg.com/vi/KALIGSRSjFs/mqdefault.jpg)
![PASULOL รามเกียรติ์ ตอนที่ 4 นนทกพบรัก [Ramakien Ep.4: Nonthok in love]](http://i.ytimg.com/vi/tMUQgmZzf_A/mqdefault.jpg)
I’m getting some of those LEDs to help me with plowing, thanks for the video!
I love mine I’m adding 2 lights to give me more light on the sides when needed.
Have you had any issues with this over heating? Our fan isn’t kicking on. Love the wiper and rearview! I’m going to look into those. The lights are great too!
@@emilyboone2778 The wiper works great but scratches the windshield.If you put one on yours I would put some easy to remove window tint on the outside side of the windshield that way if it gets scratched just peal it off and put on a new piece.I haven’t had any issues with over heating. Troubleshoot the fan by hooking power directly to it If it doesn’t come on then the fan is bad. Then troubleshoot the switch it should be on lower driver side of radiator.
@@rtdave6982 how do you trouble shoot the switch?
@@emilyboone2778 I’ll look into it did you verify your fan is good?
@@rtdave6982 hasn’t over hearted again, I guess it good. Will watch it.
@@emilyboone2778 Make sure antifreeze is to full mark on over fill tank.It’s ok to overfill it the excess will go out the drain tube eventually.
Due for my first oil change and there is controversy on whether or not to use conventional or full synthetic oil. The manual doesn't specify which and someone mentioned to me that full synthetic oil can cause clutch slippage. Any recommendations?
I use regular motorcycle oil
Put any heat shielding and noise-dampening material on the side panels yet and underneath the bed?
I haven’t and I don’t plan on doing so.
@@rtdave6982 Made a world of a difference in noise damping and it keeps the back of the bed from getting so hot. I use mine on the road a lot though.
@@jamesm568 I mostly use mine off-road at about 1/2 speed noise and heat haven’t been an issue for me so far. I’ve been busy wiring up all my accessories the last couple of weeks.
@@jamesm568 make sure to grease those u joints.
@@rtdave6982 I haven't added auxiliary lighting, but I did convert every light to LED and that made a world of a difference, especially with the LED headlights. Best thing I ever done was put a switch on the electric fan.
Does it take up a lot of battery with all those light’s because mine only have one light bar and I want multiple and a bigger sound system bar
I added a voltmeter to mine with all the front lights on The voltage only drops to about 12.5 which is good. After I run it with the lights on I always let it run some with the lights off for a few minutes before parking it. Do you have a multi meter?
Hard to say what you can add without knowing how much your light amp draw is. If you have a inline fuse for your lights which you should you can put a 10 amp fuse in the holder and see if turning the lights on blows the fuse if it doesn’t blow then your under 10 amps and good to go.
Not good shifting , just bought a Massimo, far better
Going by a Massino Might as well buy a Polaris Ranger instead
I'm seriously considering buying one of these. Do you have any issues with yours?
Yes I’ve had issues with mine take a look at my other videos for details.
@@rtdave6982 Would you still recommend one?
Yes check out the review video
450 mile 2 month review on my Coleman Outfitter UT400
th-cam.com/video/bGLXaI21Zx8/w-d-xo.html
I like mine I would recommend buying it just plug in your seat belts to avoid RPM limiting to 4000RPM I found mine at Tractor Supply on a sale discount