DIY Jeep JKU D44 Axle Bearings and Seal How to Replace

Are Your Axle Seals Leaking in your Jeep JKU or TJ with a Dana 44 then this video is a very detailed DIY on how to replace the seal and Axle Bearing
:Jeep JKU Dana 44 Yukon Gear axle seal and Bearings amzn.to/3xPqY2L
:Slide Hammer amzn.to/2ZPSh0z
:Hydraulic Press amzn.to/3okUuKA
Changing the seal and axle bearings is a complex job from removing the brakes, pulling the disc off, using a slide hammer to pull the axle. You need to take extreme care when cutting the bearing race so you don't cut into the axle shaft.
DISCLAIMER: Due to factors out of the control of Bullshitkorner and Bsk Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Bullshitkorner and Bsk garage assumes no liability or responsibility for property damages or injury incurred as a result of any information contained in this video and all other videos produced by Bullshitkorner and Bsk Garage. Use this information at your own risk. Bullshitkorner and Bsk Garage recommends safe practices when working on vehicles and/or with tools seen in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bullshitkorner and Bsk Garage Be safe! This video and description contain affiliate links, which means that if you click on one of the product links, we receive a small commission. This helps support the channel and allows us to continue to make videos like this. Thank you for the support!
#Dana44 #oilseal #leaking

[@TheBamayaker]

Good video! Great work.

[@ryanf9660]

Great video, very helpful. Thank you!

[@undefinedglory6661]

I followed this and it made it so easy to swap out on my own! My only concern was that both of my axles did not slide right back in as easy as yours did. I had to get a slide hammer to pull the old races out and upon installing the axles with new Spicer bearings, the race did not want to go in. I had to remove it from the bearing and then had to install it separately from the axle shaft.

[@danhambrick6331]

Wow..I was expecting it to put up a pretty good fight.😁😁

[@TestDontguess]

Sometimes I get off lucky

[@leakyjeep5.9]

BSK 4 life make it a bumper sticker.