No input shaping yet. I did some basic steps tuning. I will start going thru the Andrew Ellis guide next. I had an issue with random Klipper shutdowns. Turned out to be dropped communication with the USB display. Once I disabled the display in CFG it hasn't shutdown since.
@@crazynanoman I did all the tuning but as I said the hotted failed almost immediately.. would've liked to have it tested a little bit more.. in my short experience the display didn't give me any problem. however, because of the large motherboard, the cable has to be squeezed a bit too much in order to fit inside the enclosure, so it may become a weak point the future.. so far I have re printed some structural parts because the black ones had layer adhesion problems
you did input shaping or just left it stock? I'm waiting to push mine, the hotend failed after 2 prints :/
No input shaping yet. I did some basic steps tuning. I will start going thru the Andrew Ellis guide next. I had an issue with random Klipper shutdowns. Turned out to be dropped communication with the USB display. Once I disabled the display in CFG it hasn't shutdown since.
@@crazynanoman I did all the tuning but as I said the hotted failed almost immediately.. would've liked to have it tested a little bit more.. in my short experience the display didn't give me any problem. however, because of the large motherboard, the cable has to be squeezed a bit too much in order to fit inside the enclosure, so it may become a weak point the future.. so far I have re printed some structural parts because the black ones had layer adhesion problems