How to make

Set up info VCarve Pro was used in video
Bit used is #46771 Amana Tool 30° 0.005" V TIP (Any 30° 0.005 will do)
Max Carving Depth of cut is @ .058
Hatch
Dence 100 %
Line Angle @ 45°
Feed rate 90 in/min
Speed 45 in/min
Was cut using an XCarve clone
Full design video here • How to make a #PhotoVC...
Finishing Tips
Remove ALL loose wood I use a wire brush and it works awesome
Put sealer on next
Now paint the carving with ACRYLIC PAINT (water based) After painting you will need some water in a boall and a rag. Soak the rag in water and wipe MOST of the paint off. If you're using the right paint, it will wipe right off easy as pie leaving only some in cracks and places that needs to stand out. After that do a VERY LIGHT sanding if needed (220 grit max) lower would be better. Last blow off the carving to get the dust out of all the cracks and seal it one last time ..... Good Luck
Vectric VCarve Pro software link
www.vectric.co...
If you would like to support my youtube channel Please visit my Patreon page @
www.patreon.co...
My website on ETSY @ www.etsy.com/s...
My Pattern website (Made By Etsy) @ www.LittleLaru...
Follow me on Instagram @ / little_larue_apiary_llc
Fackebook Page @ / littlelarueapiary
Pinterst / ohiobeesupply
Instagram / little_larue_apiary_llc
Twitter / saveohiobees
My TH-cam Channel / beemanrobert
Thanks for Watching.

[@jeffverdin6105]

Nice! I like how you have the timer in the background.

[@BeeManRobert]

Trying to make the best video experience for everybody don’t forget to subscribe thanks for watching