Hello, I am having problems with my 2012 Hyundai Veloster Automatic, I was driving on the freeway and the Protection Mode message showed on the center console screen, I continued driving for a minute or two then the car went from 6th gear to 5th while the D started flashing, the car lost most of its power, I had to pull to the side and park the car, I did not hear any grinding noise, and the car never jittered and or showed any signs of mechanical malfunction or damage, the message appeared out of nowhere and the car wont drive faster than 2nd gear until protection mode enables again, I have connected OBD II scanners and nothing shows up, not in the engine codes, transmission codes, anywhere no Engine light on or anything, if you have had this problem before or have heard of it before if you could share some wisdom because I have no clue.
Tengo un problema con mi veloster , palpita la letra d y no entran bien las velocidades ya cambiaron la transmisión y sigue igual . Creo que necesita que la programen pero lastimosamente aquí en nj no ahí buenos mecánicos como tú .
hello, how are you, I need help, my car marks E on the dashboard, it only walks in reverse and not in drive, a scanner has already been put on it, but it marks p17c1
Learn a lot for can network troubleshooting thx a lot
I have a Playlist for can issues. You can check it out to see more videos like this.
You do a hard work. Nice
You donot buy the michel1 as far i think michel is better then alldata
@Zayad Mohsin Mitchell is good also but im used to alldata navigation.
@@DallasAutoDiag you bought it what price?
Hello, I am having problems with my 2012 Hyundai Veloster Automatic, I was driving on the freeway and the Protection Mode message showed on the center console screen, I continued driving for a minute or two then the car went from 6th gear to 5th while the D started flashing, the car lost most of its power, I had to pull to the side and park the car, I did not hear any grinding noise, and the car never jittered and or showed any signs of mechanical malfunction or damage, the message appeared out of nowhere and the car wont drive faster than 2nd gear until protection mode enables again, I have connected OBD II scanners and nothing shows up, not in the engine codes, transmission codes, anywhere no Engine light on or anything, if you have had this problem before or have heard of it before if you could share some wisdom because I have no clue.
What pump did he take apart ? And replace
Small air pump in the bottom front of the vehicle. Near the radiator
Only for turbo models instead of using the suction from intake manifold since Its aturbo model has high postive pressure .
Tengo un problema con mi veloster , palpita la letra d y no entran bien las velocidades ya cambiaron la transmisión y sigue igual . Creo que necesita que la programen pero lastimosamente aquí en nj no ahí buenos mecánicos como tú .
I'm so sorry to hear that. Where in NJ are you?
Es el sensor que esta por fuera de la transmisión esta desincronizado
I have a similar problem I don't know if you can help me I also live in dallas texas
Contact us through facebook
Hello, please where is the TCM of the Veloster located?
Do you have automatic or manual transmission?
It’s ok I already found it under the dash. It’s DCT though
@@themoment237 Where did you find it? do i have to take the radio out?
hello, how are you, I need help, my car marks E on the dashboard, it only walks in reverse and not in drive, a scanner has already been put on it, but it marks p17c1
did you find a solution? i'm in the same situation
Smart guy you doing very well brother best wishes
Thanks
👍🏻👍🏻👍🏻🌷
⚘️