Faulty Washer Control Board Replacement

แชร์
ฝัง
  • เผยแพร่เมื่อ 25 ม.ค. 2020
  • In this video I show how to access the control board on your Whirlpool Caprio model washer. A faulty control board is a very common issue with these and similar models. Be sure to watch part 2 where I show how to potentially fix a faulty control board for less than 2 bucks!
    Part 2 with washer repair: • 2 Dollar Electric Wash...
    Contact: WeakestOfWeeks@gmail.com
  • แนวปฏิบัติและการใช้ชีวิต

ความคิดเห็น • 7

  • @douglaswright1892
    @douglaswright1892 3 ปีที่แล้ว +1

    This video was informative.

  • @javiturk4636
    @javiturk4636 3 ปีที่แล้ว +1

    I believe using a putty knife under each side of the front panel housing, the unit pops back and out. Then it is easier to undo everything.

  • @Bdub-dub
    @Bdub-dub 8 หลายเดือนก่อน

    I replaced the control board 😢the washer didn't turn on nor light up

  • @victorsoriano1868
    @victorsoriano1868 2 ปีที่แล้ว

    Where did you get the control board?

    • @WeakestofWeeks
      @WeakestofWeeks  ปีที่แล้ว

      I didn't buy another control board, I fixed my faulty one: th-cam.com/video/ZmCYXt7ajpc/w-d-xo.html

  • @elmbaker1683
    @elmbaker1683 4 ปีที่แล้ว

    Why did you remove the cold/hot water lines from the wall and not just the machine?

    • @WeakestofWeeks
      @WeakestofWeeks  4 ปีที่แล้ว +2

      If I remember correctly my thought was to initially leave them attached to washer and drop the lines in a bucket to drain. Since they connect directly into the wall shut off not much of any residual water would be coming from that end. I knew the lines would have water in them but I wasn't sure how much water the actual washer would still have. Leaving them hooked up to the washer and dropping them in a bucket ensured most water from the lines and washer drained making less of a mess.