How to Replace the Thermostat - Mercedes Benz W203 C240 C320 E320 ML320 ML350 V6

แชร์
ฝัง
  • เผยแพร่เมื่อ 24 เม.ย. 2015
  • Here is a quick video on how you can remove and replace the thermostat on a 2002 Mercedes C240 with a 2.6L engine. But this procedure should be the same if not very similar for alot of Mercedes Made V6 or V8 Engines made roughly around early to mid 2000's.
    If this video helped you out please don't forget to subscribe, give it a thumbs up or if you are feeling generous leaving a tip by clicking the " i " or support button. Thank you very much for your support!
    Due to factors beyond the control of DIY Auto Repair Videos, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. DIY Auto Repair Videos assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video's. Due to factors beyond the control of DIY Auto Repair Videos, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not DIY Auto Repair Videos.
    How to remove a thermostat from a Mercedes Benz C240, how to replace the thermostat on a 2002 Mercedes C240, Thermostat replacement procedure on a 2002 Mercedes C240, How to replace the thermostat on a Mercedes E320, How to replace the thermostat on a Mercedes ML320, How to replace the thermostat on a C320, How to replace the thermostat on a Mercedes ML350, P0128 - Coolant temperature below Thermostat regulating temperature, p0128, Check engine light, code P0128, does this mean My thermostat is bad, what are some signs of a bad thermostat, what are some signs of a bad thermostat, how do I know if my thermostat is bad on my Mercedes,
  • ยานยนต์และพาหนะ

ความคิดเห็น • 26

  • @yamnjam
    @yamnjam 3 ปีที่แล้ว +4

    Thanks for posting this! It was much easier than I thought on our 2000 ML320. I had to buy that E10 tool and I didn't have mess with the pulley or belt. I didn't drain the antifreeze either, I just slid a catcher under there after I disconnected the upper radiator hose. It helps to have a few adapters or extender on the ratchet but luckily I managed. Basically once the hose is removed, it's 2 bolts. Clean r&r. I'm getting kinda handy as a gal!

  • @adolfochapa8187
    @adolfochapa8187 7 ปีที่แล้ว +9

    Thank! Very informative and fast. Thanks for not wasting time by talking too much like other vids do.

  • @TeamsterPrincess
    @TeamsterPrincess 3 ปีที่แล้ว +1

    Thank you! You were an awesome teacher!keep up the good work!

  • @alextuzla7253
    @alextuzla7253 8 ปีที่แล้ว +2

    really good information :-) thank you

  • @Mehbooba-co-uk
    @Mehbooba-co-uk 6 ปีที่แล้ว +1

    thank you ... short and sweet.

  • @ephillips5046
    @ephillips5046 5 ปีที่แล้ว +3

    I found out it is 10Nm not foot lbs. That is somewhat less than the ft. lbs. measurement. Would cause people to over tighten and possibly strip the block if they used the ft. lb measurement you threw out there. At least you said thought and told people to check. I did check and found out.

  • @rudianto5159
    @rudianto5159 3 ปีที่แล้ว

    Terimakasih untuk videonya.

  • @los-6666
    @los-6666 ปีที่แล้ว

    Thank you brotha

  • @testicularoxide5055
    @testicularoxide5055 ปีที่แล้ว

    Thanks!👍

  • @razznation6205
    @razznation6205 4 ปีที่แล้ว

    THX 👍 same Chrysler Crossfire

  • @o5carildo
    @o5carildo 7 ปีที่แล้ว

    How many Nm of Screw tightening?Tanks for the DIY.

  • @diwanatoviya1022
    @diwanatoviya1022 8 ปีที่แล้ว

    Any steps for replacing EGR on E320 2004 please help I need steps if possible pictures or video

  • @eldost82
    @eldost82 ปีที่แล้ว

    thanks

  • @moonlolo471
    @moonlolo471 6 ปีที่แล้ว

    Hello there is in my car the error of what is the way of reform
    p0170 fuel trim bank 1

  • @jeffjeffjeff2
    @jeffjeffjeff2 7 ปีที่แล้ว +1

    What symptoms will the car show if the thermostat is faulty? Can it overheat but also can it fail to reach 80c?

    • @FrettieFingers
      @FrettieFingers ปีที่แล้ว +1

      If stuck open or opens too soon. it will give you the p0128 code meaning coolant is flowing in too soon keeping the engine from reaching operating temp for a long time. If it is stuck closed, the engine will overheat. When too cool, fuel mixture can be too rich, and long term wear is possible

  • @santinialbert8432
    @santinialbert8432 9 ปีที่แล้ว

    Merci ;)

  • @user-wt1hh7nx4s
    @user-wt1hh7nx4s 8 ปีที่แล้ว

    hi
    is it the same for Mercedes c280 4matic 2006
    it really will help me
    thanks

  • @reys_live7243
    @reys_live7243 2 ปีที่แล้ว

    For what model and year mercedez Benz does it work or the thermostat look the same ??

  • @raedrabah2533
    @raedrabah2533 6 ปีที่แล้ว

    MERCID

  • @kapmak7019
    @kapmak7019 4 ปีที่แล้ว

    Hi. Mine is 79°
    can I replace it with 87° is it risky ?

  • @jameswaugh115
    @jameswaugh115 2 ปีที่แล้ว

    Do i have to drain the coolant?

  • @danbran67
    @danbran67 4 ปีที่แล้ว

    where is the replacement?

  • @ephillips5046
    @ephillips5046 5 ปีที่แล้ว

    You are doing a video. You should know what torque is. This should not be guess work.