How to Remove and Re wire Mercedes W202 Throttle Body M111 engine 1994

Hey guys here is how far i i am with the wiring i removed and and rewired the throttle body so far that was the only easy thing in this whole project
enjoy
link for DT connector amzn.to/40i9CZS
Camera used Sonny ZV1 amzn.to/3ZmCjDV
Audio Zoom Field Recorder amzn.to/3ZfAqc5
#diy #cars #mercedes

[@LvxGrave]

I had been looking for detailed videos like this one ! Thanks a lot!

[@raiderman28]

i wish you would have shown the rest of the repair. excellent content that many people want to see. i repaired one myself not knowing what i was doing, and it came out pretty good

[@buttercupaz1]

Excellent video, thank you.

[@luisr102]

Thanks bro!

[@jocventura780]

Well done .one cuestion pin # 6 are connected with the swich wires i mean continuited

[@papalangham]

nice work G

[@nemzrepairs]

Thanks 💯

[@athanasiosbellos3367]

Nice work mate . Can i ask you what type of connector will you use and how can i find it . I would like to do the same on mine throttle body. Thanks.

[@nemzrepairs]

I used a Bosch DT from Amazon

[@athanasiosbellos3367]

@@nemzrepairs Thank you sir , you are amazing . Can i have any serial,link ?

[@nemzrepairs]

@@athanasiosbellos3367 amzn.to/40i9CZS

[@athanasiosbellos3367]

You change both sides (male-female) the connectors ? In throttle body and main wirring harness?

[@nemzrepairs]

@@athanasiosbellos3367 yes the engine harness was in bits too

[@graythomason9642]

How did you disconnect the electrical cable, I can't find the connection to separate it from the harness

[@tooedwin6396]

Wondering too

[@athanasiosbellos3367]

hello again sir, finally i will try to rewire my throttle body . can i ask you what kind of wires should i use ? (i am newbie) thanks for your time , keep good work :)

[@nemzrepairs]

Use same gauge as the ones in throttle

[@athanasiosbellos3367]

@@nemzrepairs i read in a post , black is 18 gauge and all the others 20 gauge . cause i dont know from wires , awg is the correct type ? thanks again you are a very fast replier :)

[@mustaphaelkouaa462]

hellowe my brother where you living

[@nemzrepairs]

Ireland

[@zeejay8327]

How you remove that wheel with teeth?

[@nemzrepairs]

I didn’t remove the wheel you just have to solder under it skilfully try it it’s but if a pain

[@leo.portes]

where did you find the eight pin connector to replace? I'm not getting

[@nemzrepairs]

Amazon bro

[@andreilastar]

nice man i will do the same on mine🦾