Nissan r51 pathfinder and d40 navara fuel suction Solenoid

แชร์
ฝัง
  • เผยแพร่เมื่อ 7 มิ.ย. 2022
  • how's it going everyone this video we're replacing the fuel suction Solenoid and a big thank you to our subs and to that has taken the time to click on and watched the videos 👍🍻🇦🇺

ความคิดเห็น • 48

  • @victormunoz8908
    @victormunoz8908 4 หลายเดือนก่อน +1

    Very helpfull mate. Thank you very much appreciated keep up the good work

    • @pushrodtv6623
      @pushrodtv6623  3 หลายเดือนก่อน

      No worries glad i can help theres a few repair videos in the play list for the Nav's & parthfinders thanks for watching 👍🍻

  • @garymathewes6656
    @garymathewes6656 7 หลายเดือนก่อน +2

    I changed mine several time as it was going into limp mode. And it done it again then I pressurised the primer really hard and notic a leak between the hose from filter and metal tube at clamp . I tightened it as I think it was loosing pressure which caused the computer to see the loss in pressure and sent it to limp mode. Check all your fuel clamps near filter and lower near engine

    • @pushrodtv6623
      @pushrodtv6623  7 หลายเดือนก่อน

      Thanks for sharing hopefully that info can help out other push rodders ,thanks for watching 👍🍻

  • @petersaunders7636
    @petersaunders7636 2 หลายเดือนก่อน +1

    Waaay easier through the wheel arch. Removed the liner and it’s just sitting there. Always do a fuel pump reset after.

    • @pushrodtv6623
      @pushrodtv6623  2 หลายเดือนก่อน

      Thank for that great bit of info and for watching 👍🍻

  • @mpapadimonyela7508
    @mpapadimonyela7508 3 หลายเดือนก่อน +1

    Thank you. I was ready to throw away my car

    • @pushrodtv6623
      @pushrodtv6623  2 หลายเดือนก่อน

      Glad l could help and thanks for watching 👍🍻

  • @jeffreystorer4966
    @jeffreystorer4966 ปีที่แล้ว +1

    Thanks good on you

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      No worries thanks for watching 👍

  • @cristiansoria4996
    @cristiansoria4996 ปีที่แล้ว +1

    Haga video de cómo colocar las mangueritas del turbo en lanzando del solenoide asta el motor las mangueritas 😊

  • @garycarter1959
    @garycarter1959 ปีที่แล้ว +1

    Great video. Please mention how important the correct torque is when tightening any fastener. I have worked in several workshops where only torque wrenches are used to tighten any fitting.

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      Thanks for the feedback will do and thanks for watching 👍 🍻

  • @waynebee5682
    @waynebee5682 ปีที่แล้ว +1

    Thanks for video. Would like to know where you sourced the part from please.

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      G'day Wayne i got the part off ebay new it was a lot cheaper then going to Nissan thanks for watching👍🍻

  • @vflynn581
    @vflynn581 10 วันที่ผ่านมา +1

    Maf sensor

  • @conmanumber1
    @conmanumber1 8 หลายเดือนก่อน +3

    I think these need recoded after fitting new.

    • @pushrodtv6623
      @pushrodtv6623  8 หลายเดือนก่อน

      Thanks for watching 👍🍻

  • @Hyperezil
    @Hyperezil ปีที่แล้ว +1

    Had a nightmare replacing one of these. Pulled the old one off, couldn't see a gasket on the one removed. Stuck the new one on with the gasket and for some reason it doesn't seem to fully seal, no noticeable leak but if you run your finger underneath the SCV you can feel it slightly wet with diesel. Any suggestions?

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว +3

      Its highly likely the old gaskit is stuck to the main housing witch the Solonoid bolts to ,thanks for watching👍

  • @stuartchikhaula9459
    @stuartchikhaula9459 10 หลายเดือนก่อน +1

    Its nice one but please help me to switch off the engine light, my navara is not pulling

    • @pushrodtv6623
      @pushrodtv6623  9 หลายเดือนก่อน

      First id hook up a code reader or scan tool into the obd2 port and from there start with the basics like checking and cleaning electrical connetions its to hard to give an answer without looking at the car thanks for watching

  • @conmanumber1
    @conmanumber1 8 หลายเดือนก่อน +3

    Greetings again from Oamaru, Sth island New Zealand.
    Thanks for your vid.
    Question.
    Any possible causes to this misery?.
    2012 Nissan Navara D40 St-X Diesel.
    160.000 k.m on clock
    Symptoms...
    A putrid white hazy foggy smoke comes out of exhaust after around a minute of idling after startup.
    Engine has rough lumpy idle then cuts out.
    No fault codes.
    EGR valve and cooler fine.
    No overheating that i know of.
    I possibly have coolant leak but there's no coolant loss.
    No coolant in my sump oil, and no oil radiator.
    Cheers Carl

    • @pushrodtv6623
      @pushrodtv6623  8 หลายเดือนก่อน +1

      G'day Carl its a bit hard diagnosing any vehicle problem over the inter webs but ill try to point you in the right direction if you havent already get your self a work shop manuel check all the inlet piping and clamps are tight, clean the maf sencer, check the pvc system is not cloged up( positive crankcase ventilation) ,check over turbo shaft seals not leaking ,check fuel filters not blocked i hope this helps you out a bit thanks for watching mate lets us know how you got on 🍻👍

    • @conmanumber1
      @conmanumber1 8 หลายเดือนก่อน +1

      @@pushrodtv6623 Good morning and thanks. Yes I cleaned m.a.f sensor and e.g.r but will check e.g.r actuator mechanism later today when weather is calmed down.
      I'm not sure if diesels have P.c.v valve.
      Mine is a 2012 Spanish built Nissan Navara D40 St-X.
      All e.g.r circuit was decarbonized last week.
      Carl

    • @pushrodtv6623
      @pushrodtv6623  8 หลายเดือนก่อน

      Yep all engines petrol or diesel will have some form of p.c.v

  • @RoanCorporation
    @RoanCorporation ปีที่แล้ว +2

    I have automatic 2007 navarra , d40 engine , when cold car cannot even move , once warm in 20 minutes car start to get power and can move , once warm tube of fuel often jump out like there is too much pression

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว +1

      It's a bit hard to Diagnose over the TH-cams but check all electrical connections, loose fuel lines blocked fuel filter and connecting a Fault code reader check for faults check and clean the maf sensor hopefully these will head you in the right direction thanks for watching 👍 🍻

    • @Saravia611
      @Saravia611 11 หลายเดือนก่อน +1

      did you solve this problem? i have the same problem. Thank you

    • @pushrodtv6623
      @pushrodtv6623  10 หลายเดือนก่อน

      Yep problem solved car runs great after fitting new fuel Suction solenoid thanks for watching 👍🍻

  • @nategmaycock9398
    @nategmaycock9398 ปีที่แล้ว +2

    I have a loss of throttle response after revving the engine past 3500 rpm ... then a p0093 code is set . Suction control valve piston has minimal scoring but is moving freely .

    • @nategmaycock9398
      @nategmaycock9398 ปีที่แล้ว +1

      no signs of rust or debris

    • @nategmaycock9398
      @nategmaycock9398 ปีที่แล้ว +1

      Today I'm going to replace the fuel filter and all the hose clamps . Some are easy to twist though clamps are tight

    • @nategmaycock9398
      @nategmaycock9398 ปีที่แล้ว +1

      What else could cause this issue ?

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      @@nategmaycock9398 I had no codes showing, like I said in the video the valve is an electro magnet it's stuffed internally with plunger working freely by hand you can also try to power the valve on the bench and check it that way its hard to Diagnose over the TH-cams with out seeing the vehicle in person thanks for watching 👍

    • @nategmaycock9398
      @nategmaycock9398 ปีที่แล้ว +1

      Hooray... fuel filter must have been blocked . Filter is noticeably heavy .. I've replaced it this afternoon and test driven the truck and not had an issue since ...
      Something I did notice before changing the filter . The actual fuel pressure and target fuel pressure were very different... This was the biggest clue 😂

  • @GhulamUllah-tm3tr
    @GhulamUllah-tm3tr 6 หลายเดือนก่อน +1

    Mechanical job in health

    • @pushrodtv6623
      @pushrodtv6623  6 หลายเดือนก่อน

      Thanks for watching bud👍🍻

    • @GhulamUllah-tm3tr
      @GhulamUllah-tm3tr 6 หลายเดือนก่อน +1

      @@pushrodtv6623 Ghu lamUIIah

  • @coadyg
    @coadyg ปีที่แล้ว +1

    Did you experience black smoke?

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      No , no black smoke mate thanks for watching 👍

    • @nategmaycock9398
      @nategmaycock9398 ปีที่แล้ว +1

      I have black smoke and I am not hearing the turbo spool up ... truck is quite slow in general

    • @pushrodtv6623
      @pushrodtv6623  ปีที่แล้ว

      @@nategmaycock9398 check all your intake and intercooler piping hoses and clamps and your turbo if you have one

  • @warrenubindasimon8085
    @warrenubindasimon8085 ปีที่แล้ว

    I have the problem when my car