วีดีโอ

Remove the old glue with a rag and a bit of petrol.

how in the world did you get the little plastic covers off in the handle and in the door pocket?

same with my 2012 300 ima try it

I like the old kia logo and the cars better then the new ones

Where u buy the parts?

Very poor video

Thanks ❤

I could not manage to find the correct gap in the cars manual but from rockauto and other sources they all mention using a 1mm (0.040 inch) gap which is what i will be installing. thanks for the video though, i didn't figure it would be to hard to do but it's nice to see it done.

Thanks Ordered one on Amazon. Wish me Luck

What logo is that? Not Kia...

So easy! Can’t believe I almost paid someone to do this. I’ve got a 20 and a couple 30’s I need to do.

Where do you buy the new Kia logo for a good fitment of the old one?

Think this should work for my situation car ac works fine wen raining heavily (blows cold ac) but wen it’s sunny the recirculating button starts blinking again so it must be the sensor gonna give it a try and replace it

Hi I'm asking if my door Lach problem possibly replace, or need to repair, the motor or assembly aucator, ty👍

Theirs terrible! I'm glad we have great painters in Macon, GA!

Bondo that oval add new Kia logo to stop the idiots. Thanks. Also braided 50lb fishing line May work well instead of floss. Appreciate the video.

Isme shark 🦈

Pagal aurrat

Looks nice. It's not a chrome shiny finish, but the matte silver looks nice nonetheless.

You posted the obvious parts but not the wiring 😮

Learn to speak

I just did exactly the same way you guided, few minutes later the lightening bolt showed up and I lost all power, can you please help me on what to do ?

Kia pocoyo popo 0:46

Does the car need to be on when replacing it ?

Nothing else typically causes rattle, like broken plastic pieces n such?

Who made the beat ? 🔥

Like

What location. Couldn't be in Columbia SC

i have a 2017 kia rio and my driver side door doesnt fully engage into lock . it has power and moves when i press on key fob just doesnt lock all the way .

You ignored the factory crossover and tweeter. You won't be getting full range to those speakers.

MAKE IT A CHEVY

Thank you for posting this video. I thought it was going to cost me an arm and a leg to fix this problem. My 2012 300 air circulation light stays on now.👍🤙

Couldn’t remove the old residue with goo gone ? 😂

Hi guys,,question do i have to purge the liquid brakes lines? Or not necessary? Thanks

RDF-667

What about replacing it with the new logo? Or do they not have that?

just ordered mine from crutchfield too how was the install?

Good video very simple steps why they charge me 2to dollars 😂😢

what about bleeding system after all ??

Has anyone noticed power gain through this process?

+10 HP

Is it just me or am I the only one who prefers the previous version?

Is there a difference between a rio and a rio ex for this?

I wanna know how they sound

I must have missed the 'easy' bit. Don't do this, do anything else.

Gr8 info to DYI. I have a 2007 Kia Rio LX that appears to have a separate actuator. Very similar door layout. Not sure if my latch or the actuator is faulty (2 separate items in my car and actuator quite pricey). FAULT:- Front Drivers door wont unlock unless I turn key to left and lift outside handle (The key has no remote unlock/lock button). This action does not unlock other doors but other door work together with central locking action. The drivers door internal lock/unlock latch is jammed locked and seems to be a stuck cable, cannot open door from inside. When I put to key in the ignition I hear the drivers door actuator pulsing for a short time but nothing else occurs. Am I correct in saying only the latch is faulty as all mechanical cables go into it.

Love these ....classy🔥

That's not a Canadian car, otherwise you would have to cut the top bolt out due to rust. 🤬

80 FT LOWER AND THE UPPER WHAT?

I think is 72-87 foot pound.