- 66
- 483 351
Mick Zulyevic
เข้าร่วมเมื่อ 21 ก.พ. 2012
kawasaki Mule 610, how to pull engine out.
could not find any videos showing how to remove the engine, you pull it out front the right side as shown, friend recorded last bit how this helps someone!
มุมมอง: 1 472
วีดีโอ
Toyota can't keep cars !
มุมมอง 207ปีที่แล้ว
Just a video of me rambling, I drive by this toyota dealership everyday and just happened to see a new shipment of cars with quite a few having been sold already
ADV150 offroad
มุมมอง 342 ปีที่แล้ว
Just a little video of me cruising around Browns Camp Near Tillamook Oregon. I'll be getting a go pro so I I will have better footage soon :)!
How to change brakes and Rotors on a Smart Car
มุมมอง 4.3K2 ปีที่แล้ว
Hey all I hope this video helps anyone who is curious or looking to change their Rotors or brake pads on their Smart Fortwo. this applies for years 2008-2015.
How to Fix a Smart Car check engine light P0497 (2008-2016)
มุมมอง 21K2 ปีที่แล้ว
Just a little video on how to diagnose and fix the error code P0497 for a 2008-2016 Smart Fortwo. Here is the link to the part I ordered www.partsgeek.com/gbproducts/WC/29885-01377794.html?YN&PartsGeek Google Base& Smart Fortwo Purge Valve Genuine W0133-1978704 08-10 Smart Purge Valve 2009&fp=pp&gbm=a
Smart car Top speed (MPH)
มุมมอง 9K2 ปีที่แล้ว
This is my 2008 Smartfortwo passion, before you say I shifted to late it I was in automatic mode however it kept showing the gears, I had the kick down button on the throttle pressed so it would not have changed much :) GPS confirmed multiple times anywhere from 88-92 and I have hit 94 once going downhill. These are electronically limited to that speed.
Chrysler Pacifica 0-60
มุมมอง 1.7K2 ปีที่แล้ว
Just a little 0-60 of my rental 2021 Chrysler Pacifica, not bad for a minivan !
Speedometer finally installed and working !
มุมมอง 352 ปีที่แล้ว
Speedometer finally installed and working !
2020 Tesla Model Y performance 0-60 (MPH)
มุมมอง 2K3 ปีที่แล้ว
2020 Tesla Model Y performance 0-60 (MPH)
2019 Tesla Model 3 long range 0-60 (MPH)
มุมมอง 8073 ปีที่แล้ว
2019 Tesla Model 3 long range 0-60 (MPH)
Honda Grom how to install rear hub dampers
มุมมอง 5K4 ปีที่แล้ว
Honda Grom how to install rear hub dampers
Double check the check valve in the intake manifold these engines love to eat them and everyone’s quick to blame the actual Turbo PCV systems on the 1.4 are junk while you’re at it may have to replace the valve cover if it’s squeaking
100mph on a scooter is absolutely nuts 😂
Great ideia, check engine on and turbo problems, lets floor It!
Well of course ! If it's already fucked might as well fuck it some more.... in all seriousness this car was trash to begin with, at the point when I recorded the video I had given up on caring about the car. If I had actually cared I probably wouldn't have done that However the car would have been fine even though I floored it since it was in limp mode and was 1 mile from the dealership lol
Very interesting and I wonder if this also applies for grom clones being that they try to replicate ALOT of the grom stuff on the Chinese bikes
Just bought a 2013 smart fortwo pure. Great video, good tips to know, thanks., have to get some tools.😊
Had my Chevy Cruze for the last 5 years.. had to get a new engine at 120k miles then had to replace cooling system components and now ignition switch and fuel tank sensor..
Yeah unfortunately that model is just bad, I sold mine about a week after I had posted this video. I would recommend getting rid of it, it's just a terribly unreliable car
Yeah I learned the hard way.. haha I just paid it off so I’m going sell it and put that money down on a truck or something more reliable..
cheers bud
The big problem about a Chevy Cruze is being a Chevy Cruze
BRILLIANT VIDEO IN EVERY WAY!!!!!! I totally learned a lot and will be doing exactly what you instructed. BIG THANK YOU! 🤙
This is the coolest scooter I've ever seen. I'm in the process of doing research to possibly trade one of my big bikes, over 1500cc .
Thanks, it's a pretty cool bike ! If you got the cash I'd definitely recommend going for the executive version as it's a little better but still a fun ride !
i dont get how the speedo can be connected direct to battery without consuming power.
No idea I did this a while back I'm assuming it does probably have some parasitic draw
The transmission is unbelievably slow. Could take naps between shifts.
Yeah its awful 😂
Brooo lmao ive been struggling with this for hours!! Thanks for the video.
Appreciate you mine kept falling out I thought I was buggi😂😂
You try double pressing the button once it’s on yet?
What year
2014
Man, thank you. I'm Brazilian, and here, it's pretty difficult to find someone to make this kind of vídeo. I need to replace this litlle sensor, I'm not sure How do I make this replacement. Can u help me?
Interesting, mine stops at 94.
Check pcv pipe (ridged) almost looks like cable insulation.
Why do you have to drain oil
This is most likely a clogged oil feed line, causing your turbo to overheat and seize the bearing. Once your car cools down it’ll drive like normal, but I would get that checked out before the turbo explodes like mine did last summer.😂
Hazard to other drivers Tiny thing is so unsafe in a crash!
I have a 2000 I can find how to show the mph unless i dont have ir
Thanks
The waste gate can get stuck open it does it to me every once and a while the goes away.
I have a 2014 RS 2LT After 120,000 turbo started causing issues. Coil pack failure, replaced. Intake manifold caused turbo problems, Replaced. Last night I replaced the oil supply line due to a leak. Fixed the underboost code again. Luckily the car was only 8,000 bucks at 68,000 miles and paid for itself after we sold the pt cruiser (which was worse than this car by far). Otherwise I’d be pissed. I expected to run into some issues with a low end Chevy. Never buying a turbo charged Chevy ever again. Or a turbo period if I can avoid it. The majority of my issues are turbo related. It also had a coolant leak. Fixed that too.
Turbo is done my friend.
My thermostat blew out after 2 months. For sale
Clutch slipping problem
Hi I have sam problem How you fix
Check engine will give you a pretty good breakdown of what the problem is From what I just seen I’m assuming throttle positioning sensor maybe mass airflow sensor clogged catalytic converter or a turbo give me a code and I will get you a AWNSER And solution
That looks like your transmission is in limp mode
I get some problem so do you know what's wrong with it your RPM is so high please let me know if find out what's going on your vehicle please thanks
👌😎
Not stupid at all! We need more videos like this. Too many over look little things similar to that. Thanks now I know what to expect. New Grom owner didn't realize it was three years ago. Glad it's still up!
Time to twin turbo to 100+
Thanks! And the little metal retainer pin is simply pushed down not removed or popped out. Hope that helps also.
I learned to drive on an old CVT. It doesn’t sound good, but I like the smoothness of it during “hard” acceleration. Feels like a plane taking off, no jerkiness. The new ones have simulated shifts, i wish I could disable it and make it like this guy’s
How much did it cost to fix the turbo ?
It was covered under warranty but if I remember correctly at the time the invoice showed around 3-4k its been a few years so don't remember exactly
Thanks so much! I just bought a 2013 Smart fortwo with 97,000 miles on it. It seems like it has been well cared for by its only other previous owner and was garage-kept. I have already replaced the cabin air filter (almost blocked) and the engine air filter (barely off color but, what the heck). I have checked the three coils, one of which has been replaced. They all looked good. I will be replacing the spark plugs as soon as my articulated 14mm spark plug wrench shows up. I have a weird "push-back" on the break peddle that also feels like it is grinding a bit. So, my guess is I will need to do the breaks and possibly the rotor. Having said all of that, my real question is, what product are you using to clean the parts? I see the spray can, but can't make out what it is.
Just O'Reilly brand brake cleaner, it's cheaper just make sure you have a mask on this stuff is strong, good luck !
Ur reduced engine power lights on
There’s nothing WRONG with it……..other than you know….its Chevy Cruze.
Very helpful. My mechanic didn’t reset it when it was serviced. And it popped on about 500mi later. Thank you!
Gracias por tomarte el tiempo y hacer estos videos, ayudan muchísimo
Why is there a ground wire? Is it to connect the alternator body to the chassis to ground it? I don't see a ground wire going into my rectifier, only 3 wire from the 3 phases.
Thank you good Sir!! 👌👏
Thanks for this video. I believe I have an oil leak throught the gasket on this cover and this video really helps!!
Have you check the fuel filter?
That same shit happened to me. It was bc of my valve cover gasket. There was oil in my spark plugs had to get it all replaced. Cost like around 500 total i think don’t remember.
I have one just paid 2 grand to get the head gasket fixed and they fucked up kn my car and the whole thing is shitty know
@@gtaforlife320trade it in
yeah same here. I had bad misfires and decreased speeds at full throttle. it was bad ignition coils and cracked valve cover. both ending up to be $500. but before Oil/Coolant leaks from the Oil Cooler gaskets. $1000 for a $2000 job. so im not complaining...
If I bought a 1.8 NA Cruze, would I be better off than if I bought a Turbo?
Turbo adds hells problems I have one it sound good with my after market intake but there’s a new problem every week with it
@gtaforlife320 I am now looking at a 2004 Honda Accord. Probably a better buy for now but I still do love the pep of Cruzes