วีดีโอ

i just bougtht barreto log splitter,do you know what pump from northern tool it was?

Thank you!! About to do 2200 miles 😮‍💨

Hi there, this is Wibe Kielstra from the Netherlands, One question, I got a Orion 12-12-30 to for my truckcamper and have started the installation today. But i can not get the (25 mm2) 4 gauge wire (neg and pos) in to the small square holes on the bottem of the device. The inner layer of copper is to thick, there is to much copper, the diameter is to much to fit into the hole. how did you manage do that?

The big problem with these inverter generators especially the Honda is if you put bad gas in them or leave gas in them for more than 30 days, they will never run again without major major repair, the pulsar not so sure, but I would never run any generator on any gas that has any quantity of alcohol in it. These little generators sip fuel and the carburetors are tiny with capillary type passages And methanol poisoning is a real issue and will clog them at the drop of the hat and I’ve never had much success in cleaning one replacement is usually the only option if you’re careful with your fuel, you can get them to run along time, but if you’re just gonna go to the gas station and buy automotive gasoline, you may get lucky a little while, but eventually you’re gonna throw $1200 away for the Honda and $400 on the pulsar if it’s set up the same way word caution.

How did you install it? Do you have a video of that?

so many good comments on why this is NOT a valid demonstration. its a system meaning more that one part. each component needs the other for the system to function correctly. i was guilty of being a couple pumps/month guy and calling it good with the wheels on the ground until grease was everywhere and my truck was getting pushed around. unfortunately, some of us have a bd habit of learning the hard way.

Doug, thanks for the trail ride today. I miss rides in the PNW with all the forest areas. Be safe.

I found a solution in my travel trailer. I have a primetime tracer, the bedroom has one duct 4 inch. I removed the cover that directs airflow, bought a $16 4 inch square fan on amazon, looks like computer fan and has a knob to adjust speed, claims 160cfm. Came with 4 inch inline ducts and screen to protect fingers. The holes on the fan match up 100% with the 4 holes for vent. I just removed directional cover and bought longer screws. Was a 5 minute install, I happen to have a outlet on ceiling about 6 inches from vent, so looks good and the increase in flow is huge. Even on low it's double what it was, on high it's blowing great. Very happy with the flow now, probably increased it when on high 10x or more, could barely feel it before. Now if I close doors to bedroom, will actually cool down and still allows enough cooling for rest of trailer. I am thinking about adding a 4 inch elbow to have the cold air point directly to bed.

Nice vid. It’s was more of a review vid than a how to buy vid. That’s the reason I came lol wanted to hear about the process of buying it. How much it cost and stuff like that

Everyone has a cool story to tell. Im just moving a beat up jeep that my girlfriend wants to keep for her dad when he gets out of prison. XD we are moving from a rent house to our first purchased home so theres that bit of excitement.

Nice work

Cool lights bro, I can tell you really like them, but yeah they are awesome, my dad would be up set with the upgrade, only because he is old school, but once he sees them light up he would not believe what he sees😮

It would have been nice to see a few completed crimps. Thanks anyway.

There is one I saw that is 53 decibels

Great video, thanks. Yours is the first and only one I've seen that showed the tail gate folded in. Also, I just got a newer version of this trailer. I went out to see if my tail gate would fold in like yours, but mind wont. Mind will fold in, but not flat. Good enough I guess.

Boring

Thx so much for doing this!!!!

Love that floorplan. How difficult do you think it would be to remove the upper bunk so there's more headroom for the lower?

Is that tailgate/ramp sturdy enough to load a riding lawnmower?

The Arctic Fox will be our next purchase this year. Can’t wait.

Double sink for sure.

1:24 u got that backwards. If the truck was sitting level, you’d have more clearance, not less.

So the handle is a total POS, but you DID give me an idea of how to cage that sucker.

Concrete cement mixer

I just bought one yesterday

Off topic question can you use non dually trucks to install these type of trailers?

Was the tongue jack a Lippert jack? When I contacted Lippert and asked about the second set of holes on the jack so I could rotate the head, they said they didn't have has jacks with untapped holes. What gives?

Hey what size hitch ball do u use

Thanks I didn’t know about the lever

Nice trailer and very cost effective I will get one for my 8ft bass buster great vid thanks

The links are very helpful.

GREAT INFO!!!! Thank you.

Hmm not sure here…. I’ve had these hubs since 2019 on a 23’ travel trailer… use this exact unloaded greasing technique…hauled our trailer all overMI …1000 mi trips… on to Canada same miles. …..over4 Years of travel……if… If a failure would of occurred it Would!!!! Follow rules asDexter says …. Take short cuts and you will be on the side of the 😂.

Is there a maximum speed you can go with those tires? Are they rated for more than 45 mph?

Exactly what I was looking for. I have a solar charger on my batteries so I dont want to suck power from my power station to charge the batteries.

How do you reset the brake cable pedal on a auto transport system?

Why did you drill through to the interior of the Nash? Thanks.

Dude, did you really lay a metal screw driver across the top of your battery. Truly digging the LED light. Do you prefer the yellow or white for the C light? Does the headlight drown out either color more?

Thanks for showing it with the slide in. I'm considering a 24rls... Are you still happy with yours?

My question is what do you do with the red and yellow wires that came from the start capacitor and were I plugged? Leave them unplugged? If so, it looks like no wires are connected to the start capacitor post install?

Great setup...I think this is the perfect setup...much easier to travel with too.

Just to know how long does the CR123 battery last? Thx.

I had to heat one bolt to get it to break loose.

But what happens when it’s raining on travel day and the tongue jack is exposed to rain?

why would you need to run the eu2200i more than nine hours? It only takes a few minutes to refuel the less tha 1 gallon tank to run for another 9 hours.

Great video - thanks!!

Thanks for the video, wanted to see if these trailers came with straps and how everything worked. Wheel chocks certainly help but you should always put your parking brake on when loading or unloading a trailer.

Even with a new rear seal you can blow grease past it - I speak from experience. ALWAYS rotate the wheel, pump grease slowly, and do it in warm (overnight) weather when the grease flows more easily.

Thanks!

Always appreciated if something doesn't work out, suggesting new ideas or different routes to achieve the goal.