วีดีโอ

Thank you

Do we have to disconnect the water lines too? the one that feeds into the EVAP

When I programmed with the simple timer, it didn't program for every day, it was just a ONE SHOT program for the day I programmed it. That doesn't match what you said. Any thoughts? Thanks

Hi Johnathan, thanks for explaining this. I recently got a used unit that's been sitting in storage for a while and is very dirty even the outlet end is quite dusty from standing. It's been run in a coastal environment. The opposing plates are rusty and stuck to the HEPA filter on first open. So pulled the Hepa filter from Unit 2 when I removed Unit 1. Getting a quote on replacing opposing plates. Do you how often the catalyst filter should be replaced? This one on this unit is very dusty but otherwise still in tact. All in all I'm very pleased with how robust these air filters are.

i dont have a check button, what do I do?

Excellent video... thanks 🙏

Hello sir my ac running perfectly but sometimes it shows H then 85....sir what is that for any solution please sir?

Thanks, so much more helpful than the instruction booklet !

Hey, that is a great video! Thanks a lot for putting this online. One question what does "holidays" mean under the schedule menu?

My remote dont have check button lope hole......only set n reset hole😊

Thank you

Based in VIC - and interested - what kind of efficiency gains/savings would we expect to see in our heating over winter? Are there any studies done on this?

My daikin is turning on green light but no air coming from it? do you know what this is?

Reverse cycle? More like "Really cool information; thank you!" 👍

You mentioned solar power in passing. Is the heat pump directly solar powered?

Hi, after I cleaned my air purifier the red light indicator is still on. How do I reset it?

To my delight on 32 degree night 40 degree day, turning off the isolation switch then back on worked, thankyou so much Jonathan and may the Lord Jesus Bless You in Everyway 😊

I happened to broke a thin wire. Is there a fix? Whats the purpose of those thin wires?

2nd press of cancel repeated after 00 long beep. If you cycle through each error code a long beep is the error. If 00 = ok

Hi there. A great video thanks. I have set up two schedules NR 1 and NR2. NR1 is purely heating and energy management. NR2 is the one I want to use now to cool anything 23 and above and heat anything below 16. A few questions: - At what point can I tell which one (of NR1 and NR2) I am in? - Given that NR2 both heats and cools, if I didn’t start the programming from the Auto, page is there a way to correct that or do I have to restart from Auto? - is there a symbol on the HMI that tells the user that the program is active even though it might be outside an “ON” period? Thanks

Did a cashie install with one these, compressor will not even kick in going to go take a look at it this afternoon. Will not be installing a Panasonic unit ever again.

When you say PRESS CANCEL then “KEEP pressing” do you mean keep yr finger holding the down position or multiple presses? I’ve tried both. Holding the cancel switch no error code appears. When I hit cancel continuously every error code appears one after the next. What should I do? Thank you I did do the reset and this worked.

Good day. Can I block heat and fan mode so the brc1e63 only can stay on cool mode?

A5

I have a brand new CS-RZ35 Panasonic split, and it's the noisiest air con I have ever had, to noisy to sleep with it on, I have no idea what the problem with it might be.

You need to do a video how to operate these horizon breezair units. We moving into a new rental property and it has one off these units and I’d like to no how to work it because it’s getting hot now and we don’t have normal aircon.

XO

Whats the meaning of XO? thats the letter appear in display panel of the remote

Kenapa di menu saya tidak ada schedule? Apakah ada yang salah? Mohon bantuan🙏

Thanks, problem fixed after 0:43 of viewing this video. Cheers!

Thank you

Thanks to you, I fixed my shit… thanks

Hi, may I know how do I disable the orange light blinking for WLAN? Thank you.

I got H00 But the compressor turns off while is on auto mode. Is that normal?

Right. I still don't get it.

What's the cost?

Is there a solution when it won't turn on at all?

Our problem is he heating isn't working. Your can hear the unit outside but no heat comes out. The timer light doesn't blink. Unit is only 2years old. Checked and no fault codes. Only H00

hello good morning. What happens if the thermostat loses power? Are the selected settings lost? How long can the thermostat go without power without losing the preset settings?

I don’t see “schedule” option in my menu, can you help me?

Hi, why do i see a temperatures for "cool" and "heat" when i set the action to OFF?

R5

Good video, thanks mate

U4

15,000pcs Vent Cover on the way to MEL😁

Thanks for the video I just did all the vents for my grandma.👍

Thank you! We'll be sharing this with all of our tenants :D

Hi, just to confirm: if you set Cool 24 and Heat at 16; it means that if temperature drops below 16, the system will turn on and heat until it reaches 16-17 and then it turns off? and similarly, if the house gets to say 26, the aircon will turn on until temperature drops to say 24-23?.

is this program still available from the vic gov? how do i claim these covers? please guide.

Having trouble to get the hook to stay, any suggestions