KAWASAKI Voyager and Vaquero Accessory connections

Connections plug and play under the seat and under the fairing

[@m.a.bustamante217]

This taught me more about my Vaquero's electric circuits than the service manual

[@foozvideo7816]

Thanx à lot

[@a.b1266]

Excellent, just what i was looking for thanks.

[@h.wayneb3495]

Appreciate you sharing video. Thank you

[@rcafmaintainer3723]

Busy front end lol. Thanks 🙏 didn’t know about the front accessory. I’m adding LED lights on my engine guard.

[@macaroyo2]

Thanks for the tutorial was very helpful

[@foozvideo7816]

You are welcome

[@joe2479]

Thanks! Great video.

[@patrickdavis7815]

thanks good info easily explained....

[@drec.134]

Great video! 👏🏾👏🏾👏🏾👏🏾👏🏾👏🏾👏🏾

[@foozvideo7816]

Thank u Dre C

[@ERICPJ54]

great job!

[@foozvideo7816]

Thanks

[@BackRoadzRider]

good info...

[@javiparra2937]

Excelente...... :)

[@tstillman]

Very informative video. I'll be using it in the near future. (';' )

[@Silverado21]

For the two rear accessory under seat, im going to put side led markers for running lights. Does it matter which I plug into and do they shut off once bike is turn off?

[@goshell]

is there any accessories plug in the back for a trailer ?

[@anthonygadams]

Is there a port to hook up a diagnostic tool or gage?

[@brucebarquist202]

Can I use the front accessory plug to power a Wolo air horn rather than running from the battery?

[@av8dr]

Very useful information. Thank you. Do you think I can connect an air horn to the connectors in the fairing (with relay of course)?

[@foozvideo7816]

I wouldnt cuz it takes a lot of amps..for a horn. I would connect to the battery

[@greghernandez5444]

THANK YOU SO MUCH for the info on all the accessories leads that was so helpful, I saw where you pointed out the rear speaker leads but
Where are rear speakers leads in front. I'm thinking of buying the same cerwin vega amp that you have on your bike, do you like your amp??
Once again Thank You So Much on your in formative Video.

[@foozvideo7816]

Thw front seakers tou follow rhe 2 wires on back of each speaker. They take you to the head unit radio

[@macaroyo2]

Where did you coect the ground -

[@invinciblerao]

Thank you for putting an effort to make a video. I have a question? What type connector we need to use to connect to these accessory power outlets? I am planning to install led lights but should I install at the end of these light wires so they just can plug into.

[@foozvideo7816]

Bullet connectors. I made my own

[@foozvideo7816]

Yes you can. I used bullet connectors

[@ammodan56]

What size are the bullet connectors that work in the accessory ports

[@foozvideo7816]

I used red normal size

[@RanGer-498]

How is your amplifier holding up? Any issues with it since it's not marine certified. Thank you.

[@foozvideo7816]

So far so good..never had an issue...the amp i used at the end is PBR300x2

[@linosnoto]

where do i get flat to usb connector

[@lamarcoker819]

HOW DO YOU CHANGE THE SPARK PLUGS ON THE VOYAGER

[@foozvideo7816]

Under the gaz tank. I havent changed it yet

[@xgwsailor]

Do you have to remove the front speakers in order to remove the fairing?

[@foozvideo7816]

Yes you have to remove the chrome pièce and then the speakers behind Wich there is a long plastic cylinder for acoustic which is connected to the fairing.. Other then that you have 2 10mm bolts under each glove pocket and you've to remove the 5 screws of the windshield and the last one is under the head light

[@xgwsailor]

Ok thanks

[@xgwsailor]

Did u replace the radio also? If so, did u add the RC PAC?

[@foozvideo7816]

Hi there . I didnt replace the radio and i ended up changing the Amp to a pbr300x2 and didn't use PAC. Just connected from stock speakers wires to Amp and from Amp to new speakers.

[@foozvideo7816]

yes

[@xgwsailor]

What’s your email address?