How to Repair and Clean a Bambu AMS, or How to Remove the AMS's First Stage Feeders
ฝัง
- เผยแพร่เมื่อ 22 ต.ค. 2023
- The first video on the channel, this is a teardown for cleaning and upgrading the Automated Material System, AMS for the Bambu P1S. This goes in detail for a thorough breakdown and removal of the bowden tubes, first stage feeders, motors, and internal components.
- วิทยาศาสตร์และเทคโนโลยี
Hi! Suggestion, title this "How to remove the first stage feeders" and you will get a lot more views. Its very helpful, thank you!
Why did you not just a vac to clean it out
I didn’t have a vacuum small enough. Plus each time I tried something different, it got worse until I tore it apart.
@@Yinzer3D vacuum won't really work. I tried. Started a bit your way, and then thought of pressure air. So took it to the compressor which worked flawlessly for this same purpose.
One of your screws is in the box you tipped the used dessicant into
Thanks. Found it when I cleaned up, only to lose it again a few hours later.
@@Yinzer3D I always forget to put the 2 main screws back in until I see them on the countertop later. But for how much I have to take this thing apart I should just leave them out.
How many stepper does this system use? Is it one for each filament?
You should also clean the 4 in 1 out splitter piece too
"Right there". WHERE?? There are screws everywhere and you did not point to anyone. Which ones of the dozens of screws are you talking about??
they did some bullshit the new AMS is different it wont let you pull the tube