Got mine and it came with a few things assembled already - the large CF tubes and supports were already glued into the fuse (not very neatly, unfortunately) as well as the landing gear and motor mounts. Also wound up with 2 CF rods about 1.5 mm x 8 in. and I have no idea what purpose they serve. The slot for the wing was also cut at a bit of an angle rather than 90 degrees. Other than these inconsistencies, the kit arrived with everything fitting together quite nicely, I usually build from scratch so this was a treat!
Some work to put together but looks a lot easier than most profile foamies. Think I will make one my Xmas present to myself. I am with you on flying these kinds of planes hand launched.
Got mine and it came with a few things assembled already - the large CF tubes and supports were already glued into the fuse (not very neatly, unfortunately) as well as the landing gear and motor mounts. Also wound up with 2 CF rods about 1.5 mm x 8 in. and I have no idea what purpose they serve. The slot for the wing was also cut at a bit of an angle rather than 90 degrees.
Other than these inconsistencies, the kit arrived with everything fitting together quite nicely, I usually build from scratch so this was a treat!
Do you need servo wire extensions for the rudder and elevator? You never mentioned that.
Why didn't you glue the wing halves together??
PLEASE DO THE SKYNETICS YAK 1100MM Build video
Some work to put together but looks a lot easier than most profile foamies. Think I will make one my Xmas present to myself. I am with you on flying these kinds of planes hand launched.
Why didn't u show the rudder rod install just to show us noobs?
Also the online manual shows the elevator rod to the bottom
What a piece of junk....it flys like crap