How to Make A Slider Float for Pike Fishing

Sometimes it is great to make your own fishing gear. I decided to try making my own sliding floats when float fishing for pike.
I've used:
Round Styrene Tube 3mm outer diameter, 2.1mm inner diameter
Straight Cork 2mm x 38mm, 5 per float
Starglow UV Neon Smart Paint 120ml
THANKS FOR WATCHING, PLEASE SUBSCRIBE AND HIT THE BELL TO BE NOTIFIED OF MY NEXT VIDEO
Recommended Dry Fly Floatant
www.dryflypowd...
Follow me on Instagram for photos of my fishing, hiking and wild camping:
/ westcountryangler
My Facebook Page:
/ westcountryangler
My website which is a collection of photos and videos:
www.westcountry...
Don’t forget to subscribe to get updates of my next videos!
#deadbaiting #pikefishing #canalpike

[@BUSHCRAFTTOOLS]

Watching your own home-made float 'going under' must be, as you say, "The best feeling".
This was a great instructional vid and I'm sure viewers would like to see more of these hacks!
How about a Pike fly tying vid followed by targeting some pike...all within the same 24hrs?
24hr Challenge: Tie --> Fish --> Pike

[@paulclarke267]

if you use a product called sand and seal it will mke your finnished float look a lot more professional

[@markhensel1843]

thanks for the video - please keep posting

[@robertreid7221]

Who needs the perfect uniformity of a soulless machine when one can create something with heart ?
✌❤ Bob.

[@WestCountryAngler]

Thank Bob, I'm not a naturally creative person but there's a lot of satisfaction in using something I've made. Thanks for watching

[@asianseaanimals]

Thanks for sharing good stuff for fishing

[@injones3683]

Top floats, top tips!

[@ChrisBagley-c2n]

Good video from a technical viewpoint, no backs of hands, fingers, off camera work and excellent audio.
Making holes through the cork/balsa, I use what is known as a mattress needle. It is used to repair damaged mattresses. They are about 30cms long with a sharp point. They can be pushed through the cork/balsa segments so the holes will automatically line up. They do need a bit of firm pushing but they should all line up with care. (E Bay for the needles) I then super glue (gel) it won't run. the segments together keeping the glue off the needle. The needle then goes into the drill chuck you are using the drill as a lathe (i have a
cordless drill) stand the drill on the battery case and using the slowest speed and 120 grit sandpaper smooth out any misalignment. Much easier than by hand. Round off the ends leaving a small flat at each end. Then keeping the same set up apply the paint first coat to the rotating float. Much quicker and easier. Keep the drill slow! Finish the painting up to your satisfaction. Then remove the needle from the chuck and holding the assembly ease out the needle and at the same ease the plastic tube in to follow the needle out. Glue the tube in and then carry on to finish the float off. That is a quicker and easier way to make a float, I think so anyway!