DeWalt impact driver anvil and chuck replacement

How to fix a broken chuck and how to replace the anvil on a Dewalt Impact driver.

[@jorgemolina9695]

*I absolutely love this set **MyBest.Tools** should have upgraded to the 20V sooner. The impact driver is a must have for driving screws; compact and all muscle.*

[@highgroundcomics2525]

I just wanna say thanks brother. Because of your video I was able the change the anvil assembly for $20. Instead of spending $150 on a new drill. You're the man 🤜🏾🤛🏾✌🏽

[@nathandenbow5924]

Hey man! just wanted to say thanks a lot for posting this video, it was super helpful in the repair of my dewalt impact gun! I really appreciate you taking the time and my repair was a success! Thanks again!

[@TheBearGrylz]

The chuck spring is dewalt part NO78434. The little steel ball amazon will sell you that does in fact fit is N089668. That ball number is listed black and decker but fits. You might not have to replace the little anvil thing or take apart the whole gun. I just removed the snap ring and the chuck slide itself and that was enough to repair the common broken spring.

[@BrobMaryland]

Im just going to replace the spring lol. I bought the new 20v brushless set. Now i have 2 awesome drill sets with a small repair.

[@bricefletcher9602]

Thanks man awesome video only one that I found that actually did the chuck and the works got my gun fixed thanks again

[@jackhenson2900]

Hey Brendon love your vids. FYI I use a mechanics pic to remove the spring. Makes it easier to do.

[@samson6359]

Very good video for fixing this kind very common problem! You save my time and $$!

[@BrunoMartinsNeto]

I was planning to do it but then I figured out that I need my drill to take out the screws \m/

[@langston1aladdin]

Thanks. Very helpful. Just did mine today.

[@vaguincolombia]

good video brendan, just a little thing, if i were you, id have cleaned everything and re-grease everything with new grease it doesnt need much just a little

[@blazerson9068]

How do you know if anvil is worn out? I replaced spring that holds ball bearing and bit was still not holding well. Should I now replace anvil?

[@metricstormtrooper]

Thanks for the video, just what I needed.

[@hhprogressiveconstruction1140]

I have the opposite problem damm thing never what’s to come out . Thanks for sharing with us 👍 .

[@Lifeguruonafence]

Is it essential to take the chuck spring out in order to get the gearbox to come apart?

[@6530mary]

Thank you, very useful!!👏🏻

[@JennyAndAlex]

This helped. Thank you!

[@TheBearGrylz]

Thank you for this video.

[@azamalmajed4080]

Please, may you add part numbers of these parts

[@jimmay210]

Thanks for what you do....Lighting was VERY BAD of subject matter!

[@gerardolopez277]

Is the anvil hollow? Reason I ask is because I have a Brocken drill bit in mine

[@nmlindon20]

Why my do just hammering after assembly 😅

[@jordanreece1767]

You can bend the retainer with a flathead

[@TheSrklop79]

Amazon had this drill in a drill only without battery for $59 ..wouldnt it just be easier to buy a new one...lol

[@MoparGuy1625]

Russ Polk no bc real men fix their shit.

[@davidvasey1955]

Only if you have €59 to through away

[@frankviramontes3887]

Mine still holds the bit but it just spins won't move would the anvil be the problem then. Tried screwing a bolt and I believe something snapped inside over tighten. Any help is appreciated